User manual CYBEX INTERNATIONAL 8840

[. . . ] Part Number 8830-999-4 BravoTM 8830/8840 Owner's Manual Strength Systems www. cybexintl. com Table of Contents Safety Safety Guidelines And Practices . 3 6 7 8 9 Assembly Machine Specifications. . 22 25 27 28 29 Customer Service Product Registration . . 30 30 31 32 32 Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. [. . . ] Install individual weight plates one at at time. Position each weight plate so wide edges of bushings face upward and narrow edges of bushings face downward. RE COR CT WRO NG Wide bushing edge faces upward 3. Snap guide rods into position. The narrow bushing edge must face downward. 13 Cybex Bravo 8830/8840 Owner's Manual Cable routing 1. Verify cable is routed through top of pulley bracket and then route cable end to top weight connector. Pull cable tight and secure in place with spiral pin using a 3/16" pin punch and a hammer. Cable Pulley Bracket Top Weight Connector Roll Pin Cable Routing Cable Pulley Bracket Top Weight Connector Roll Pin Weight Stack Connector Pin Pulley bracket connects to top weight connector 14 Cybex Bravo 8830/8840 Owner's Manual 3. Place weight stack pin in each plate to verify proper installation. Lift top weight up and down simulating normal operation (without selecting any resistance). Verify that the cable is moving smoothly and is routed straight from the pulley bracket to the top of the weight plate connector. Weight stack decals 1. Choose the appropriate decal; pounds, kilograms or both. When peeling off back cover, make sure the decals remain attached to the front sticker. Align holes in decal with appropriate holes in weight stack. Do not allow the adhesive to touch weight stack at this time. Insert a guide pin through each hole of the template. A guide pin can be anything that fits through the weight stack hole, such as a weight stack selector pin. Align decal and rub it onto weight plates. Remove front side, leaving decals adhering to weight plates. Pounds Kilograms Install back shroud 1. Secure top in place using two BHSCS and 7/32" Allen wrench. 15 Cybex Bravo 8830/8840 Owner's Manual If 1. Move to desired location. Then Two people will be required for this procedure 8830/8840canfit through a doorway 2. Remove the four shipping cones using a 3/4" socket or wrench. Remove the four shipping cones using a 3/4" socket or wrench. [. . . ] All parts can be found on the web at www. cybexintl. com Shipping Address Contact Name Include a description of the problem. In addition to your shipping address and contact name, your account number is helpful but not required. You may also fax orders to 508-533-5183. MATERIAL: DIMENSIONS IN INCHES ALL MATERIAL MUST COMPLY TO EUROPEAN UNION DIRECTIVE 2002/95/EC RoHS (RESTRICTION OF HAZARDOUS SUBSTANCES) FINISH: EXCEPT AS NOTED REMOVE ALL BURRS BREAK SHARP EDGES . 005/. 010 R SURFACE FINISH INDICATED PER ANSI B46. 1-1985 GENERAL TOLERANCES: 2 DECIMALS ± . 03 3 DECIMALS ± . 015 ANGLES ± 1° FEATURES SHOWN PERPENDICULAR OR PARALLEL SHALL BE SO WITHIN ± 1° REMOVE CARBURIZATIO AND SCALE FROM LASE AND PLASMA CUT EDGE GENERAL MACHINING 125 31 Cybex Bravo 8830/8840 Owner's Manual Return Material Authorization (RMA) The Return Material Authorization (RMA) system is used when returning material for placement, repair or credit. The system assures that returned materials are properly handled and analyzed. Follow the following procedures carefully. [. . . ]