User manual CYBEX INTERNATIONAL BRAVO 8840

[. . . ] Part Number 8830-888-4 BravoTM 8830/8840 Owner's Manual Strength Systems www. cybexintl. com Table of Contents Safety Safety Guidelines And Practices . 10 Customer Service Maintenance Contacting Service . . 14 17 19 20 21 Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Bravo® and its mark are registered trademarks of Cybex International, Inc. [. . . ] All anchoring holes must be used to maximize stability. Equipment must be secured to a solid, level surface to eliminate rocking, tipping, or falling over due to incorrect usage and misuse. The solid, level surface should not deviate more than 1/8" over a 10' distance or as defined and required by local building and architectural codes. Anchoring of equipment must be completed by a qualified licensed contractor. Due to the wide variation of flooring on which machines may be anchored or installed, verify anchoring method and anchoring fasteners with a qualified and licensed contractor. A minimum pull out force of 220 lbs/100 kgs is required for each anchor position. PROPER USAGE Use equipment only as described in the manual or on the placards located on each machine. Failing to follow proper instructions may result in injury. STANDARD COMPLIANCE Cybex products meets applicable ASTM and EN Standards. 6 Cybex Bravo 8830/8840 Owner's Manual Regular Maintenance Activities Preventative maintenance activities must be performed to maintain normal and safe operation of your equipment. Keeping a log sheet of all maintenance actions will assist you in staying current with all preventative maintenance activities. The preventative maintenance actions are described in detail in the maintenance section of this manual. Briefly, they include: Daily Clean upholstery. Weekly · · · · · · Inspect all nuts and bolts for looseness. Inspect all cables and belts for damage or wear. If a cable or belt is worn or damaged, immediately discontinue use until cable or belt has been replaced. Check for worn handles, worn snap links, and worn warning labeling. Replace all loose or worn grips immediately. Inspect weight stacks for proper alignment and operation. Correct all improper alignment and operation issues immediately. Lubricate guide rods using automotive engine oil only. Yearly Replace all cables and belts at least annually. 7 Cybex Bravo 8830/8840 Owner's Manual Warnings and Cautions Warning decals indicate a potentially hazardous situation that could result in death or serious injury if the precautions are not observed. Caution decals indicate a potentially hazardous situation, which, if not avoided, could result in minor or moderate injury. The diagram following the decals show where each decal is located. D WITH OLD TEXT. 12 PT ARIAL FONT R . 25 4 PLACES 2. [. . . ] The following conditions may indicate a worn cable: Cables Condition of Cable A tear or crack in the cable sheath that exposes the cable Diagram A kink in the cable A curled sheath Necking - A stretched cable sheath Belts Condition of Belt Peeling of the belt's skin. 3D View 3D or Side View Wave in belt 17 Cybex Bravo 8830/8840 Owner's Manual Condition of Belt Belt is necked down (narrow section) 3D View 3D or Side View Replace belt if any Examine edge of belt (both sides). section is over 1/32" Replace belt if any section is (. 03) narrower than the narrower than the rest. rest of belt Cracks or splits One or more strands of kevlar is hanging out, or if there is a significant amount of frayed kevlar. 18 Cybex Bravo 8830/8840 Owner's Manual CAUTION: Personal injury or property damage may occur if the following precautions are not followed. [. . . ]