User manual CYBEX INTERNATIONAL PRO3 (550T) TREADMILL

[. . . ] Cybex Pro3 Treadmill Owner's Manual Cardiovascular Systems Part Number LT-21311-4 E www. cybexinternational. com Cybex Pro3 Treadmill Owner's Manual Cardiovascular Systems Part Number LT-21311-4 E Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Safety SentryTM is a registered trademark of Cybex international, Inc. Polar® is a registered trademark of Polar. DISCLAIMER: Cybex International, Inc. makes no representations or warranties regarding the contents of this manual. [. . . ] Press the Speed + ­ keys to change the belt speed at any time. The right display will show the current speed. Press the Incline V keys to change the incline at any time. The left display will show the current incline. Press the Stop key at any time. Operation Page 3-2 Cybex Pro3 Treadmill Owner's Manual Detailed Operation Guide NOTE: Maximum user weight is 400 lbs. Plug the treadmill power cord into a power outlet from a grounded, dedicated circuit, rated for one of the following: 115 VAC ±5%, 60 Hz and 20 amps; 208/220 VAC, 60 Hz, 15 amps or 230 VAC ±5%, 50 Hz and 15 amps. Locate the on/off (I/O) power switch on the left side of the treadmill. Toggle it to the on (I) position to supply power to the internal treadmill components and illuminate the control panel. CAUTION: Do not stand on the running belt when starting the treadmill. Always place your feet on the two top steps when beginning a workout. Place your feet on the two top steps located on each side of the running belt. Clip the e-stop clip onto your clothing and carefully test the e-stop key to ensure it will fall off properly in case of an emergency. See Emergency Stop Key (e-stop) in chapter 1 for properly testing the estop key. Also, see Stopping the Treadmill in this chapter for further information about the e-stop key. NOTE: Be sure the string is free of knots and has enough slack for you to run comfortably with the e-stop key in place. You now have the option to select a program or enter Manual Mode. To select a program, press a program key and follow the prompts. Upon entering a program the LEDs flash, prompting you to adjust the appropriate settings. This is referred to as Program Setup Mode. If the Quick Start key is pressed now, all defaults for that program will be accepted. After 10 seconds, if no key has been pressed, the first default will be accepted. After another 10 seconds the second default will be accepted and so on until the last default. [. . . ] Provide the model and serial number of your treadmill. The serial number is located on the front panel of your treadmill. The serial number begins with a letter, for example: R09-101331100. At Cybex's discretion, the technician may request that you return the problem part(s) to Cybex for evaluation and repair or replacement. [. . . ]