User manual CYBEX ATON

[. . . ] Comfort for your child it is essential to read and follow the entire instruction manual carefully. Correct Order: Baby seat initial setup - fasten child - fasten baby seat in the car. For proper protection of your child, it is essential to use and install the CYBEX ATON according to the instructions given in this manual. According to local codes the product characteristic can be different. [. . . ] When securing your child with a twopoint belt, this may result in injuries or death of the child. ⷠMake sure that the horizontal marking on the safety sticker p is parallel to the floor. ⷠPull the three-point belt over the child seat. Insert the lap belt k into the blue belt guides m on both sides of the car seat. ⷠPull the diagonal belt l in driving direction to tighten the lap belt k. ⷠPull the diagonal belt l behind the top end of the baby seat. Bring the diagonal belt l into the blue belt slot n on the back. In some cases the buckle q of the car safety belt may be too long and reach into the belt slots of the CYBEX ATON, making it difficult to install the ATON securely. If this is the case please choose another position in the car. rEMOVING THE CAR SEAT · Take the seat belt out of the blue belt slot n in the back. ⷠOpen the car buckle q and take the lap belt k out of the blue belt slots m. SECURING YOUR CHILD CORRECTLY For the safety of your child please check . ⷠIf the shoulder belts c fit well to the body without restricting the baby · If the buckle tongues t are fastened in the buckle e INSTALLING THE BABY SEAT CORRECTLY For the safety of your child please make sure . ⷠThat the ATON is positioned against driving direction (the feet of the baby point in the direction of the backrest of the car seat) · If the car seat is installed in front, that the frontairbag is deactivated · that ATON is secured with a 3-point belt · That the lap belt k is running through the belt slots m on each side of the baby seat · That the diagonal belt l is running through the blue belt hook n on the back of the baby seat That the car buckle q is not reaching all the way to the blue belt slot m · That the car belt is tight and not twisted · that the ATON is vertically installed on the car seat (see marking) Note!The CYBEX ATON is exclusively made for forward facing car seats, which are equipped with a 3-point belt system according to ECE R16. REMOVING THE INSERT The insert, which is preinstalled when purchased, helps to support lying comfort and fit for the smallest babies. In order to remove the insert please loosen the cover in the baby seat, lift the insert a little bit and take it out of the seat. The adjustable insert x (left picture top of page 36) enhances the comfort of the child up to approx. Later the insert can be removed to give the child additional space. OPENING THE ATON CANOPY Pull the canopy panel away from the seat and turn the canopy up. To fold away the canopy lift the canopy panel slightly and turn the canopy back to its basic position. oPENING THE ATON BASIC CANOPY Pull the canopy cover over the carrying handle adjustment. [. . . ] ⷠPull the shoulder belts c with the buckle tongues t out of the cover parts. ⷠPull the buckle e through the seat cover. ⷠNow you can remove the cover parts. The child seat must never be used without the cover. [. . . ]