User manual CYBEX CALLISTO

[. . . ] Your child's safety is your responsibility. Always use the harness system to prevent your child from falling or sliding out of the seat. This vehicle is suitable for one child only. ­ Follow all instructions carefully to avoid incorrect handling as this can impair the stroller's correct function. [. . . ] Do not tumble dry and do not expose to direct sunlight!OPENING THE STROLLER a) Before opening the pushchair the safety lock needs to be unbuckled. B) After releasing the safety clip you can unfold the pushchair. C) Step on the footboard until it locks in place with an audible click. D) Please make sure that the handle bar is safely locked as well. Make sure that both mudguards point outwards. F) After assembling the wheels the bowden brake cable can easily be lodged into the designated slots. AUTOMATIC FRONT WHEEL SWIVEL LOCKS ­ Regardless of their position, the front wheels can be automatically locked into place by stepping on the lock button (wait for an audible CLICK). To release the lock press again until you hear a CLICK. USING THE HARNESS SYSTEM a) To fasten the harness system insert left and right side fasteners into the central harness buckle. B) To tighten the belts pull the strap on the front of the central harness buckle. C) To release the belt system press the release button located on the seat in front of the belt lock while pulling at the shoulder belts. D) To release the fasteners squeeze the grooves on left and right side of the central harness buckle. E) Adjust the length of the crotch strap with the corresponding slider under the seat cover. ADJUSTING THE HARNESS SYSTEM FOR NEWBORNS ­ Release the loops at the end of the shoulder straps from the triangle in the belt system, situated at the bottom of the backrest under the seat cover. ­ Completely pull the shoulder straps out of the holes in the backrest. ­ Feed the shoulder straps through the two bottom holes. Make sure to feed the straps back through the holes in the backrest mechanism and re-attach them to the triangle. ⭠To adjust the length of the shoulder straps to newborns please attach the inner loop of the shoulder strap ends to the triangular ring. Switch back to the upper holes as soon as the shoulder straps do no longer fit over the child´s shoulders. REMOVING THE HEADHUGGER AND SHOULDER PADS a) Remove the headhugger as soon as the headhugger does no longer fit over the child´s shoulders. B) Remove the velcros of the headhugger on the top left and right side on the back of the seat cover. [. . . ] ­ Reverse this procedure to refit the seat cover and the harness. Make sure that the seat tubes slide back into the pockets inside the seat cover. F) Lie-flat position: Put the rear flap over the seat's back rest and fixate it with the two velcros underneath. B) Unhook the side panels at the left and right upper end out of the adaptor. [. . . ]