User manual CYBEX CALLISTO CARRYCOT

[. . . ] ­ Be aware of the risks presented by an open fire and other heat sources such as electrical heaters, gas flames etc. Especially if they are in the immediate vicinity of the carry cot. Remove the mattress, the boot cover and the adapters until the bottom board and the two metal bracing strips can be seen (Picture 1). Push the two metal bracing strips into the dedicated brackets at the bottom of the carry cot. [. . . ] Take off the seating unit of the CYBEX Callisto Buggy (instructions on how to do this can be found in the instruction manual of the buggy). Now insert both supplied adapters (one on each side) from the front onto the frame and slide along until they engage. Now click on the rear support parts on the left and right top tubes. Please ensure that they are locked in the defined position by the lock pin and the respective holes on the frame. From the front, guide the carry cot onto the frame of the buggy and place the pins attached on left/right side of the carry cot onto the rear support on the frame. Let the two front adapters engage with the buggy. Push from the inside of the carry cot onto both adaptors to ensure that they have engaged correctly. Finally connect the elastic straps with the press buttons on the rear leg (left / rigth side) (Picture 5) WARNING: PLEASE ENSURE THAT ALL LOCKING DEVICES ARE ENGAGED BEFORE USE USE WITH CYBEX ATON / CYBEX CARRY COT The supplied adapters can be used on both the carry cot and the CYBEX Aton. When using the carry cot the adaptors have to be hinged down. For the CYBEX Aton the ends of the adaptors need to be hinged up. for further information please refer to the manual of the CYBEX Aton car seat. To take off the adapter lift up the rear part of the adapter and pull off to the front. To take off the carry cot release the two elastic straps from the rear tubes and press the buttons on the adapter (on both sides of the buggy). The button will be kept in this position and the system is unlocked. CLEANING: ­ After removing the metal bracing strips, the mattress and the wooden base the carry cot can be washed at 30 ° using the sensitive care/gentle cycle. ­ Please read the care instructions on the label. Before re-use let the Callisto carry cot dry out completely. the textiles used were tested by CYBEX. [. . . ] To obtain such warranty it is required to take or ship the product to the retailer, who initially sold this product to a customer and to submit an original proof of purchase (sales receipt or invoice) that contains the date of purchase, the name of the retailer and the type designation of this product. This warranty shall not apply in the event that this product is taken or shipped to the manufacturer or any other person other than the retailer who initially sold this product to a consumer. Please check the product with respect to completeness and manufacturing or material defects immediately at the date of purchase or, in the event that the product was purchased in distance selling, immediately after receipt. In case of a defect stop using the product and take or ship it immediately to the retailer who initially sold it. [. . . ]