User manual CYBEX CLOUD Q

[. . . ] The following brief instructions are only intended to provide an overview. In order to achieve maximum security and comfort for your child it is absolutely imperative that you read the whole instruction manual carefully. Order of tasks: set up infant car seat - strap child in install infant car seat in vehicle. R16 oder gleichwertigem Standard Homologation CYBEX CLOUD Q – infant car seat ECE R44/04 age group 0+ weight: 0 to 13kg age: from birth up to approx. [. . . ] The infant car seat must not be used in the reclining position in a vehicle. In order to ensure this, the belt guide is automatically locked as soon as the seat is put into the reclining position. €• Place the lap belt (k) into blue belt guides (m) on both sides of the infant car seat. €• Tighten lap belt (k) by pulling on diagonal belt (l) in the direction of the front of the vehicle. €• Pull diagonal belt (l) behind the head end of the infant car seat. Do not twist the vehicle seatbelt while doing this. €• Route diagonal belt (l) through the rear blue belt guide (n) and ensure the belt is placed above the L. Diagonal belt (l) must be routed through rear, blue belt guide (n) and above the unfolded telescopic Linear Side-impact Protector (L. €• Now swing the carrying handle (a) with both buttons (b) pressed, into the vehicle position A (see page 12) WARNING!It may be that buckle part (q) of the car seatbelt is too long so that is reaches the blue belt guides of the infant car seat. This means that the infant car seat cannot be fastened tightly. If this is the case, choose another seat in the car for the infant car seat. This system enhances the safety of your child in the event of a side crash. In order to achieve the best possible protective effect, fold the L. Out as far as possible towards the car door closest to the infant car seat. You will hear a „CLICK“ when it is locked. Touches the inside of the car door when in its outermost position, you must use the intermediate position. To do so, you first have to unfold the L. Then press unlocking button (f) and push the L. Can be completely pushed back into the seat if you press unlocking button (f) at the same time as moving the folded out part towards the seat with a gentle pressure. If installing the infant car seat on a middle seat, you must not fold out either Linear Side-impact Protectors (L. The folded out Linear Side-impact Protector (L. [. . . ] •• Weight (age , height) of the child. Further information about our products can be found at WWW. Falls Schäden vorhanden sind, darf das Produkt nicht mehr 46 The following guarantee conditions are only valid in the country in which this product was initially sold by a retailer to a consumer. The guarantee covers all manufacturing and material faults that were present at the time of purchase or that became apparent within three (3) years following initial sale of this product by a retailer to a consumer. [. . . ]