User manual CYBEX ONYX

[. . . ] Read these instructions carefully before use and keep them for future reference. Your child`s safety may be affected if you do not follow these instructions. BUMPERBAR(NUR TOPAZ) a) Slide in latches on left and right side into gadgets sewn into the seat fabric. Your child´s safety is your responsibility. [. . . ] A dry and/ or dusty environment can have a negative effect on the wheel systems. To avoid this it is very important that the wheel systems will be regularly checked, cleaned and lubricated. this will ensure a smooth operation of the stroller in daily use. Please follow the instruction below to maintain the wheel systems (wheel axles & suspension system). -I Check of wheel systems a) Wheel system must be cleaned before applying the lubricant. B) Wheel system must not be broken or damaged. For eliminate squeaking on you CYBEX buggy take only WD 40 and follow the mentioned pictures below. Insert always a cloth or a carton in order to leave no oil stains. Please pay special attention to not apply the lubricant on any other part of the stroller (fabrics, tubes, etc. -II Applying of the lubricant a) Rear Wheel - Spray from the rear side of the buggy in the space between the rim and the housing on both sides. let the lubricant get into the system for approx. B) Front Wheel - Spray in the space between the rim and the housing on both sides. let the lubricant get into the system for approx. should this not avoid the squeaking , please remove the rim cap and apply the spray on the axle. C) Suspension - Apply some lubricant between the suspension slider and the housings. DISPOSAL When you are done using your CYBEX Onyx/Topaz, a proper disposal is important. Garbage disposal can be different in every country. Please contact your local waste management company to make sure you are taking the right steps to dispose of the CYBEX Onyx/Topaz. Always follow the disposal regulations of your country. ASSEMBLING THE FRONT WHEELS ­ Fit the front wheels to the end of the frame until they engage with a "click". Ensure the bowden cable is inserted into the clips on both sides. ATTACHING THE BUMPER BAR (TOPAZ ONLY) a) Slide in latches on left and right side into gadgets sewn into the seat fabric. [. . . ] F) Feed the strap with the slider (6) of the central harness buckle through the hole in the seat fabric. g) Feed the loops on the end of the shoulder straps through the triangle in the backrest (7). H) Feed the shoulder straps through the holes in the seat fabric (8). I) Open the press buttons which are on the left and the right side from the seat on the bottom from the fabric. [. . . ]