User manual D-LINK DES-2218

[. . . ] 10/100Mbps Ethernet/Fast Ethernet Switch Model DES-2218 User's Guide Rev. 02 (October, 1997) 6DES2218. . 02 Printed In Taiwan RECYCLABLE Wichtige Sicherheitshinweise 1. Bitte lesen Sie sich diese Hinweise sorgfältig durch. Heben Sie diese Anleitung für den spätern Gebrauch auf. [. . . ] Super User and General User Privileges 26 Using the Console Interface DES-2218 Ethernet Switch User's Guide establishing a Super User, you are now ready to operate the Switch. Now issue a LOGOFF command from the main menu, the login screen1 appears as follows. Login On The Switch Console By Registered Users Figure 6-5. Type in your password and press Enter. If the Switch is not used within five (5) minutes, the following message appears at the bottom of the console's main menu: "Console time out press ENTER to continue. . . " At this time, press ENTER and login screen will be displayed. 1 Using the Console Interface 27 3. With the cursor on the OK selection, press Enter. The main menu screen will be displayed based on your Super User or General User access level or privilege. The following describes the differences between the user privileges. Changing your Password To change your user password: 1. Choose User Account Change from the main menu. Type in your old password and press Enter. Type in the new password you have chosen, and press Enter. Type in the same new password in the following blank to verify that you have not mistyped it. Choose the SAVE command to let the password change take effect. 28 Using the Console Interface DES-2218 Ethernet Switch User's Guide 7. This method can also be used by a Super User to change another user's password. Adding and Deleting Users Access to the console, whether using the console port or via TELNET, is controlled using a user name and password. Up to three of these user names can be defined. The console interface will not let you delete the current logged-in user, however, in order to prevent accidentally deleting all of the users with Super User privilege. Only users with the Super User privilege can add new and delete users. Adding a New User To add a new user: 1. Choose User Account Change from the main menu. Figure 6-7. Choose Create New User from the User Account Change menu. Using the Console Interface 29 3. Enter the new user name, and assign an initial password. Determine whether the new user should have Super User or General User privileges. Figure 6-8. Choose SAVE and press Enter to let the user addition take effect. Choose EXIT to leave the Create New User menu. Deleting a User To delete a user, 1. Choose User Account Change from the main menu. [. . . ] Traps sent to the host will use community name community, which may be a string up to 32 characters long. PFT-Entry mac-address recv-port allowed-ports Adds entries to the switch's forwarding table. The mac-address corresponds to the source Ethernet address, in the form xx:xx:xx:xx:xx:xx. The recv-port is the port from which packets from the station may be received. [. . . ]