User manual D-LINK DES-5200

[. . . ] DES-5200 Fast Ethernet Switching System User's Guide Rev. A1 (July, 1999) 651S5200. K13 Printed In Taiwan RECYCLABLE i Copyright © 1999 by D-Link Systems, Inc. All rights reserved. Limited Warranty Hardware: D-Link warrants each of its hardware products to be free from defects in workmanship and materials under normal use and service for a period commencing on the date of purchase from D-Link or its Authorized Reseller and extending for the length of time stipulated by the Authorized Reseller or D-Link Branch Office nearest to the place of purchase. This Warranty applies on the condition that the product Registration Card is filled out and returned to a D-Link office within ninety (90) days of purchase. [. . . ] Follow these steps to change user passwords: 1. Enter the user's name in the User Name field. Enter the user's old password in the Old Password field. Enter the new password in the New Password field. Reenter the new password in the Confirm Password field. Managing the DES-5200 62 Fast Ethernet Switching System User's Guide 5. Select Save and press Enter to save your changes. Managing the DES-5200 63 Fast Ethernet Switching System User's Guide Switch Port Configuration The Switch Port Configuration panels are used to configure individual ports on the DES-5200. The only difference between the panels is the port number that they deal with. The options and settings are the same for each. Select the group of ports that you want to configure and then go to the appropriate panel. Follow these steps to select a panel: 1. Decide which group of ports you would like to work with. Select the group on the Console Program panel. Press Enter to go to the appropriate panel. Managing the DES-5200 64 Fast Ethernet Switching System User's Guide Switch Port Configuration Menu The Switch Port Configuration menu, displayed in Figure 38, enables you to change the configurations of individual ports. Figure 38: Switch Port Configuration State All ports have two states: enabled or disabled. Enabled ports transmit and receive data packets. Disabled ports can not transmit or receive packets. Physical Refers to the physical state of the port. If the port state is manually changed it will not change states. It will not auto negotiate speed and duplex mode. All TX ports can be in the following physical states: · Auto · 100Tx/Half · 100Tx/Full · 10Tx/Half · 10Tx/Full Ports in the Auto state automatically negotiate speed and duplex mode. Ports set in the 100Tx/Half physical state are set to work at 100 Mbps half duplex. Ports set in the 100Tx/Full state are set to work at 100 Mbps full duplex. Managing the DES-5200 65 Fast Ethernet Switching System User's Guide Ports set in the 10Tx/ Half state are set to work at 10 Mbps half duplex. Ports set in the 10Tx/Full state are set to work at 10 Mpbs full duplex. The 100BASE-FX ports can only be in the 100/ Half or 100/Full states. [. . . ] 71, 114 SNMP Trap Manager Setting. . . . . . . . . . . . . . . . . . 72, 115 Software Update. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45, 92, 100 Software Update Configuration . . . . . . . . . . . . . . . . . . . . . . 51 Software Update Menu. . . . . . . . . . . . . . . . . . . . . . . . . . . 51, 100 Software Version. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45, 93 Spanning Tree Algorithm. . . . . . . . . . . . . . . . . . . . . . . . 67, 110 Spanning Tree Configuration . . . . . . [. . . ]