User manual D-LINK DES-6000

[. . . ] DES-6000 Modular Ethernet Switch User's Guide Second Edition (April 2001) 6DES6000. . 02 Printed In Taiwan RECYCLABLE TABLE OF CONTENTS ABOUT THIS GUIDE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V CONVENTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V OVERVIEW OF THIS USER'S GUIDE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Model numbers are normally used only to differentiate between specific Switches where necessary. Unless differentiated by model number, all information applies to both models. Overview of this User's Guide Chapter 1, "Introduction. " Describes the Switch and its features. [. . . ] If the packet doesn't have a VLAN tag or the port is not a member of the VLAN (doesn't have the same VID) as the packet, the packet will be discarded. Note: If a port is a member of a trunk group but is not the anchor, the items shown in the above table will be read-only and the values will be the same as those for the anchor port. Choose Configure Port VLAN ID (PVID) to access the second item on the 802. 1Q VLAN Configuration menu. The following screen appears: Figure 6-38. Port VLAN (PVID) Assignment screen This screen allows you to set a Port VLAN ID number (PVID) for each port. All ports are assigned PVID = 1 when VLANs are enabled. Press APPLY to let the changes take effect. Note: If a port is a member of a trunk group but is not the anchor, the items shown in the above table will be read-only and the values will be the same as those for the anchor port. Choose Port GVRP Configuration from the 802. 1Q VLAN Configuration Menu to access the following screen: Figure 6-39. Port GVRP Configuration Screen Using the Console Interface 59 Modular Ethernet Switch User's Guide This screen allows you to Enable or Disable Group VLAN Registration Protocol (GVRP) for each port. When GVRP is Enabled, a user attached to the port's Ethernet segment can dynamically join an 802. 1Q VLAN that has been previously defined on the switch. When GVRP is Disabled, then no dynamic VLAN registration is allowed on this port. Choose Configure 802. 1Q Static VLANs to access the fourth item on the 802. 1Q VLAN Configuration menu. The following screen appears: Figure 6-40. 802. 1Q Static VLAN Settings screen The fields you can set are: VID Enter a VLAN ID from 1 to 4094. This is the VLAN that will be defined on this screen. All ports are designated members of VID 1 when VLANs are enabled. Tag/Untag Toggle between T for Tagging Port and U for Untagging Port for each member port. Egress/Forbidden/Non-Member Position the cursor over the dash "­" representing the appropriate port number and press <space bar> to select E for Egress, F for Forbidden or leave the dash "­". An E designates the specified port as a static member of the VLAN. An F defines the port as a non-member and also forbids the port from joining a VLAN dynamically. A dash (­) means the port is not given VLAN membership for the VID entered above. [. . . ] Disclaimer of Other Warranties: EXCEPT FOR THE LIMITED WARRANTY SPECIFIED HEREIN, THE PRODUCT IS PROVIDED "AS-IS" WITHOUT ANY WARRANTY OF ANY KIND WHATSOEVER INCLUDING, WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT. IF ANY IMPLIED WARRANTY CANNOT BE DISCLAIMED IN ANY TERRITORY WHERE A PRODUCT IS SOLD, THE DURATION OF SUCH IMPLIED WARRANTY SHALL BE LIMITED TO THE DURATION OF THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE. EXCEPT AS EXPRESSLY COVERED UNDER THE LIMITED WARRANTY PROVIDED HEREIN, THE ENTIRE RISK AS TO THE QUALITY, SELECTION AND PERFORMANCE OF THE PRODUCT IS WITH THE PURCHASER OF THE PRODUCT. Limitation of Liability: TO THE MAXIMUM EXTENT PERMITTED BY LAW, D-LINK IS NOT LIABLE UNDER ANY CONTRACT, NEGLIGENCE, STRICT LIABILITY OR OTHER LEGAL OR EQUITABLE THEORY FOR ANY LOSS OF USE OF THE PRODUCT, INCONVENIENCE OR DAMAGES OF ANY CHARACTER, WHETHER DIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL (INCLUDING, BUT NOT LIMITED TO, DAMAGES FOR LOSS OF GOODWILL, LOSS OF REVENUE OR PROFIT, WORK STOPPAGE, COMPUTER FAILURE OR MALFUNCTION, FAILURE OF OTHER EQUIPMENT OR COMPUTER PROGRAMS TO WHICH D-LINK'S PRODUCT IS CONNECTED WITH, LOSS OF INFORMATION OR DATA CONTAINED IN, STORED ON, OR INTEGRATED WITH ANY PRODUCT RETURNED TO D-LINK FOR WARRANTY SERVICE) RESULTING FROM THE USE OF THE PRODUCT, RELATING TO WARRANTY SERVICE, OR ARISING OUT OF ANY BREACH OF THIS LIMITED WARRANTY, EVEN IF D-LINK HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. THE SOLE REMEDY FOR A BREACH OF THE FOREGOING LIMITED WARRANTY IS REPAIR, REPLACEMENT OR REFUND OF THE DEFECTIVE OR NON-CONFORMING PRODUCT. [. . . ]