User manual D-LINK DFE-580TX GUIDE D INSTALLATION RAPIDE

[. . . ] DFE-580TX PCI Fast Ethernet Server Adapter User's Guide Second Edition (April 2001) 6DFE580TX. 02 Printed in Taiwan RECYCLABLE Copyright Statement No part of this publication may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation / D-Link Systems Inc. , as stipulated by the United States Copyright Act of 1976. FCC Certifications This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] · SNMP alerts based on any of the 4 adapter states--built-in software sends alarms and alerts to any SNMP Management Console based on various states and conditions of each network. . 2 10/100 PCI Fast Ethernet Card 2 Installation Minimum Hardware Requirements · · · · · · Intel Pentium-class processor mouse or compatible pointing device CD-ROM drive VGA video adapter 32 MB RAM 2 MB HDD space Operating System Requirements · · Microsoft Windows NT 4. 0 (with Service Pack 6, Service Pack 5, with Service Pack 3 and NDIS Hot Fix, and with Service Pack 4 and Roll-up Hot Fix) Microsoft Windows 2000 Installation of a Server Card requires hardware installation first, then software installation. The Server Card requires a universal bus PCI connection and enough room behind the connector to accommodate a full-length card. Unpacking and Inspection CAUTION: Under ordinary circumstances, the Server Card will not be affected by static charge as may be received through your body during handling of the unit. In special circumstances where you may carry an extraordinarily high static charge, it is good practice to reduce the charge by touching a ground before handling the adapter card. Open the shipping carton and carefully remove all items. In addition to this User's Guide, ascertain that you have: · One Ethernet Adapter Server Card. · Server Card Software CD-ROM Installing the Adapter 1. Shut down the computer, unplug its power cord, and remove the chassis cover. Insert the contact edge of the Server Card into the connector of any available PCI Bus Master expansion slot. Press the card firmly into the connector and ascertain that the card's contacts are fully seated in the connector. Install the bracket screw that secures the card to the computer chassis. Replace the computer's chassis cover. Connect all the cable in your group. 3 10/100 PCI Fast Ethernet Card 6. Reconnect the computer's power cord, and switch computer power on. If the BIOS section of your computer's boot program is Plug and Play compliant, then at power-up the BIOS will automatically configure any newly installed Server Card adapter. NOTE: Due to a fault in some Plug-n-Play BIOS programs, it happens occasionally that a newly installed adapter is assigned an Interrupt Number which is already assigned to another device. In such a case, the conflict of Interrupt Number will cause faults in the behavior of both devices. Then it is necessary to run the CMOS Setup utility, and manually assign a nonconflicting Interrupt Number. Connecting the Network Cable Category 5 UTP cable qualifies for both the Fast Ethernet and Ethernet cabling rules. The maximum length of any single cable run between any station and its supporting hub is 100 meters. The maximum length of a cable joining two switches is 10m in general, but is 100m when both switches qualify as Ethernet Class 2 Repeaters (all D-Link Ethernet switches qualify). However, these cable runs may need to be shorter than the given individual maximum lengths because their lengths are globally restricted by the rule that the maximum aggregated cable run between any two stations is 205m. Up to 4 cables can be used in any combination per Server Card. Connecting for Fast Ethernet (100Mbps) Category 5 UTP cable is required for Fast Ethernet operation. The maximum cable run between the Server Card and the supporting switch is 100m. The cable must be straight (not a crossover cable), with a RJ-45 plug at each end. [. . . ] 6/b, 20154, Milano, Italy TEL: 39-02-2900-0676 FAX: 39-02-2900-1723 URL: www. dlink. it E-MAIL: info@dlink. it 10F, 8-8-15 Nishi-Gotanda, Shinagawa-ku, Tokyo 141, Japan TEL: 81-3-5434-9678 FAX: 81-3-5434-9868 URL: www. d-link. co. jp E-MAIL: kida@d-link. co. jp Michurinski Prospekt 49, 117607 Moscow, Russia TEL: 7-095-737-3389 & 7-095-737-3492 FAX: 7-095-737-3390 URL: www. dlink. ru E-MAIL: vl@dlink. ru INDIA D-Link India ITALY D-Link Mediterraneo Srl JAPAN D-Link Japan RUSSIA D-Link Russia SINGAPORE D-Link International 1 International Business Park, #03-12 The Synergy, Singapore 609917 TEL: 65-774-6233 FAX: 65-774-6322 E-MAIL: info@dlink. com. sg URL: www. dlink-intl. com Unit 2, Parkside 86 Oak Avenue, Highveld Technopark Centurion, Gauteng, Republic of South Africa TEL: 27 (0) 126652165 FAX: 27 (0) 126652186 URL: www. d-link. co. za E-MAIL: attie@d-link. co. za P. Box 15036, S-167 15 Bromma, Sweden TEL: 46-(0) 8564-61900 FAX: 46-(0) 8564-61901 E-MAIL: info@dlink. se URL: www. dlink. se 2F, No. 119 Pao-Chung Rd, Hsin-Tien, Taipei, Taiwan TEL: 886-2-2910-2626 FAX: 886-2-2910-1515 URL: www. dlinktw. com. tw E-MAIL: dssqa@tsc. dlinktw. com. tw S. AFRICA D-Link South Africa SWEDEN D-Link Sweden TAIWAN D-Link Taiwan U. K. D-Link Europe 4th Floor, Merit House, Edgware Road, Colindale, London NW9 5AB U. K. [. . . ]