User manual D-LINK DFL-1600 COMMAND LINE INTERFACE REFERENCE GUIDE

[. . . ] Network Security Firewall CLI Reference Guide DFL-210/ 800/1600/ 2500 DFL-260/ 860 Ver. 1. 01 Security Security Network Security Solution http://www. dlink. com CLI Reference Guide DFL-210/260/800/860/1600/2500 NetDefendOS version 2. 12 D-Link Corporation No. 289, Sinhu 3rd Rd, Neihu District, Taipei City 114, Taiwan R. O. C. http://www. DLink. com Published 2007-04-17 Copyright © 2007 CLI Reference Guide DFL-210/260/800/860/1600/2500 NetDefendOS version 2. 12 Published 2007-04-17 Copyright © 2007 Copyright Notice This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. [. . . ] DynamicRoutingRuleAddRoute Description A routing action is used to manipulate and insert new or changed routes to one or more local routing tables. Properties Index Destination OverrideStatic OverwriteDefault OffsetMetric OffsetMetricType2 The index of the object, starting at 1. (Identifier) Specifies to which routing table the route changes to the OSPF Process should be exported. (Default: No) Allow overwrite of default route. (Default: No) Increases the metric by this value. (Optional) Increases the for Type2 routers metric by this value. DynamicRoutingRuleAddRoute Chapter 3. Configuration Reference LimitMetricRange Limits the metrics for these routes to a minimum and maximum value, if a route has a higher or lower value then specified it will be set to the specified value. (Optional) Always select all interfaces, including new ones, for publishing routes via Proxy ARP. (Default: No) Specifies the interfaces on which the security gateway should publish routes via Proxy ARP. (Optional) Text describing the current object. (Optional) ProxyARPAllInterfaces ProxyARPInterfaces Comments Note If no Index is specified when creating an instance of this type, the object will be placed last in the list and the Index will be equal to the length of the list. 80 3. 16. EthernetDevice Description Hardware settings for an Ethernet interface. Properties Name EthernetDriver PCIBus PCISlot PCIPort Media Duplex MACAddress Comments Specifies a symbolic name for the device. (Identifier) The Ethernet PCI driver that should be used by the interface. PCI bus number where the Ethernet adapter is installed. PCI slot number used by the Ethernet adapter. Some Ethernet adapters have multiple ports that share the same bus and slot number. This parameter specifies what port to be used. Specifies if the link speed should be auto-negotiated or locked to a static speed. (Default: Auto) Specifies if the duplex should be auto-negotiated or locked to full or half duplex. (Default: Auto) The hardware address for the interface. (Optional) Text describing the current object. HighAvailability Description Configure the High Availability cluster parameters for this system. Properties Enabled ClusterID SyncIface NodeID HASyncBufSize HASyncMaxPktBurst HAInitialSilence Enable high availability. [. . . ] (Default: Yes) Enable reporting of the number of bytes received by the user. (Default: Yes) Enable reporting of the number of packets received by the user. (Default: Yes) Enable reporting of the number of seconds the session lasted. (Default: Yes) Enable Interim Accounting Messages to update the accounting server with the current status of an authenticated user. [. . . ]