User manual D-LINK DGE-528T

[. . . ] 27 2 Introduction The D-Link DGE-528T is ideal for the small office or home office environment. After completing the steps in this manual, you will have the ability to share information and resources - such as files and printers - and take full advantage of a “connected” environment for work and play!The DGE-528T comes with drivers for the most popular operating systems and can be integrated into a larger network. However, this manual is designed to help you network two computers running Windows 95/98, Windows Me and Windows 2000 in a peer-to-peer configuration. [. . . ] All the configuration settings are displayed as shown below. Checking the IP Address in Windows XP/2000 Type ipconfig /renew at the prompt to get a new IP Address. click Release and Renew to obtain a new IP Address. ) 16 Assigning a Static IP Address Note: Residential Gateways/Broadband Routers will automatically assign IP Addresses to the computers on the network, using DHCP (Dynamic Host Configuration Protocol) technology. If you are using a DHCP-capable Gateway/Router you will not need to assign Static IP Addresses. If you are not using a DHCP capable Gateway/Router, or you need to assign a Static IP Address, please follow these instructions: Go to Start Click on Control Panel Click on Network Connections 17 Assigning a Static IP Address continued Highlight Internet Protocol (TCP/IP) Click Properties Select Use the following IP Address in the Internet Protocol (TCP/IP) Properties window Input your IP Address and subnet mask. (The IP Addresses on your network must be within the same range. For example, if one computer has an IP Ad dress of 192. 2, the other computers should have IP Addresses that are sequential, like 192. The subnet mask must be the same for all the computers on the network. Double-click the “D-LinkDGE-528T Gigabit Ethernet PCI Adapter” to read the explanation of the problem. This information will be helpful if you require technical support from D-Link. Verify Cable Connections Check to see that the computer(s) you are troubleshooting are properly connected. Each computer must be connected from its DGE-528T with Category 5 UTP cables. Examine the Network cables and ensure that they have not been damaged by walking-on, rolling over with chairs, or closed in doors. Additionally, make note of and alleviate any possible electromagnetic interference that may be affecting your network. Your network cables can be plugged into any port on your hub except the “Uplink” port. The “Uplink” port is only used when connecting your hub to another hub or switch. Understanding Indicators Your DGE-528T has indicators or lights that can give you information about your network traffic and help you determine problems when troubleshooting. Your DGE-528T have two indicators labeled “ACT” and “LINK” on their back panels. A steady green “LINK” light indicates a good connection with the switch. A flashing green “ACT” light indicates that the Network Adapter is sending or receiving data. [. . . ] Contents subject to change without prior notice. d-Link is a registered trademark of D-Link Corporation/D-Link Systems , Inc. All other trademarks belong to their respective proprietors. Copyright Statement No part of this publication may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems Inc. [. . . ]