User manual D-LINK DGL-4100

[. . . ] Table of Contents Contents Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Minimum System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Features and Benefits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The router must reboot before new settings will take effect. You will be prompted to Reboot the Device or Continue. If you need to make additional settings changes, click Continue. If you are finished with your configuration settings, click the Reboot the Device button. 26 D-Link Systems, Inc. Using the Configuration Interface Routing Add/Edit Route Adds a new route to the IP routing table or edits an existing route. Enable: Destination IP: Specifies whether the entry will be enabled or disabled. The IP address or network that the packets will be attempting to access Note: 192. 168. 1. 0 with a Netmask of 255. 255. 255. 0 means traffic will be routed to the entire 192. 168. 1. x network. Netmask: Used to specify which portion of the Destination IP signifies the network trying to be accessed and which part signifies the host that the packets will be routed to Note: 255. 255. 255. 255 is used to signify only the host that was entered in the Destination IP field. Gateway: Specifies the next hop to be taken if this route is used. A gateway of 0. 0. 0. 0 implies there is no next hop, and the IP address matched is directly connected to the router on the interface specified: LAN or WAN. Specifies the interface, LAN or WAN, that the IP packet must use to transit out of the router when this route is used. The amount of hops it will take to reach the Destination IP or network. A hop is considered to be traffic passing through a router from one network to another. If there is only one router between your network and the Destination network, then the Metric value would be 1. Saves the new rule or modified existing rule to the Rules list. When you are done editing the settings, you must click the Save Settings button at the top of the page to make the changes effective and permanent. Advanced > Routing Interface: Metric: Save: Route List This section shows the current routing table entries. Certain required routes are predefined and cannot be changed. Entries on this list that can modified can be enabled/disabled by toggling the Enable checkbox. Editable entries can be modified by clicking on the paper and pencil icon. To delete an editable entry, click on the trash can icon. After you've completed all modifications or deletions, you must click the Save Settings button at the top of the page to save your changes. The router must reboot before new settings will take effect. You will be prompted to Reboot the Device or Continue. If you need to make additional settings changes, click Continue. If you are finished with your configuration settings, click the Reboot the Device button. [. . . ] This limited warranty provides specific legal rights and the product owner may also have other rights which vary from state to state. Trademarks: D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks or registered trademarks are the property of their respective manufacturers or owners. Copyright Statement: No part of this publication or documentation accompanying this Product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems, Inc. , as stipulated by the United States Copyright Act of 1976. Contents are subject to change without prior notice. [. . . ]