User manual D-LINK DGS-1008D

[. . . ] D-LinkTM DGS-1008D 8-Port 10/100/1000Mbps Gigabit Ethernet Switch Manual Rev 3. 00 Building Networks for People RECYCLABLE D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch ____________________ Information in this document is subject to change without notice. Reproduction in any manner whatsoever without the written permission of D-Link Corporation is strictly forbidden. Trademarks used in this text: D-Link and the D-LINK logo are trademarks of D -Link Corporation; Microsoft and Windows are registered trademarks of Microsoft Corporation. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. [. . . ] Insert the T3 x 15 L screws into the wood wall. Hook the mounting holes at the back of the switch onto the screws. The wall-mount process is complete. (1) 3/4 inch minimu m for a wooden wall. (2) 3 inch minimum for a cement wall. Figure 2 - 1. Mounting the Switch to a Wall Attaching the Rubber Feet § Use the rubber feet provided. Position and apply the rubber feet to the underside of the DGS-1008D Switch. Figure 2 -2. Attaching the Rubber Feet CAUTION: Do not place any device on top of Switch, or place the Switch on top of any device or object that will block the free flow of air through the ventilation slots on the sides, top, and bottom of the Switch's case. In addition, care should be taken not to locate the Switch next to, on top of, or underneath any device that generates a significant amount of heat. For the Switch to perform at its optimal level, the Switch must have adequate ventilation to prevent the Switch from overheating and becoming damaged. 7 7 D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Power On Plug one end of the AC to DC power converter into the power connector of the Switch and the other end into the local power source outlet. After the Switch is powered on, the LED indicators will momentarily blink. This blinking of the LED indicators represents a reset of the system. Power Failure As a precaution, in the event of a power failure, unplug the Switch. When power is resumed, plug the Switch back in. 8 8 D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Section 3 Connecting The Switch Switch To End Node Switch To Hub or Switch Connecting To a Server NOTE: All 8 high -performance NWay Ethernet ports can support both MDI-II and MDI-X connections. Switch To End Node End nodes include PCs outfitted with a 10, 100, or 1000 Mbps RJ-45 Ethernet/Fast Ethernet Network Interface Card (NIC) and most routers. An end node can be connected to the Switch via a twisted-pair Category 3, 4, 5, or 5e UTP/STP cable. The end node can be connected to any of the ports of the Switch. Figure 3-1. Switch connected to an end node The Link/Act LEDs for each UTP port light green when the link is valid. The LED over the port label indicates a port speed of either 10/100 Mbps or 1000Mbps. A blinking LED on the bottom indicates packet activity on that port. Switch to Hub or Switch These connections can be accomplished in a number of ways using a standard Ethernet cable. · · · A 10BASE-T hub or switch can be connected to the Switch via a twisted-pair Category 3, 4, 5, or 5e UTP/STP cable. A 100BASE-T hub or switch can be connected to the Switch via a twisted -pair Category 5 UTP/STP cable. A 1000BASE-T switch can be connected to the Switch via a twisted -pair Category 5e or better UTP/STP cable. 9 9 D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Figure 3-2. Switch connected to a port on a hub or switch using either a straight or crossover cable­any standard Ethernet cable is fine Connecting To Network Backbone or Server Any of the five Gigabit Ethernet ports are ideal for uplinking to a network backbone or network server. Figure 3-3. Connection to a Server 10 10 D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Appendix A Technical Specifications General Standards: IEEE 802. 3ab 1000BASE -T IEEE 802. 3u 100BASE-TX IEEE 802. 3 10BASE-T IEEE 802. 3x Flow Control IEEE 802. 1p priority Queues Protocol: Data Rate: Transfer CSMA/CD Ethernet: 10Mbps 20Mbps Fast Ethernet: 100Mbps 200Mbps Gigabit Ethernet: Topology: Network Cables: Star Ethernet: Fast Ethernet: 2-pair UTP Cat. 3, 4, 5, Unshield Twisted Pair (UTP) Cable 2-pair UTP Cat. [. . . ] India TEL: 91-022-26526696/56902210 FAX: 91-022-26528914 URL: www. dlink. co. in Middle East (Dubai) P. O. Box: 500376 Office No. :103, Building:3 Dubai Internet City Dubai, United Arab Emirates Tel:+971-4-3916480 FAX:+971-4-3908881 URL: www. dlink-me. com Turkey Regus Offices Beybi Giz Plaza, Ayazaga Mah. No:28 Maslak 34396, Istanbul-Turkiye TEL: +90 212 335 2553 FAX: +90 212 335 2500 URL: www. dlink. com. tr Egypt 19 El-Shahed Helmy, El Masri A l-Maza, Heliopolis Cairo, Egypt TEL:+202 414 4295 FAX:+202 415 6704 URL: www. dlink -me. com Israel 11 Hamanofim Street Ackerstein Towers, Regus Business Center P. O. Box 2148, Hertzelia -Pituach 46120, Israel TEL: +972-9-9715700 FAX: +972-9-9715601 URL: www. dlink. co. il Latin America Isidora Goyeechea 2934 of 702, Las Condes Santiago ­ Chile, S. A. TEL: 56 -2-232-3185 FAX: 56-2-232-0923 URL: www. dlink. cl Brasil Av das Nacoes Unidas, 11857 - 14 - andar - cj 141/142 Brooklin Novo Sao Paulo - SP - Brazil CEP 04578-000 TEL: +55 11 55039320 FAX: +55 11 55039322 URL: www. dlinkbrasil. com. br South Africa Einstein Park II Block B 102-106 Witch-Hazel Avenue Highveld Technopark Centurion Gauteng Republic of South Africa TEL: 27 -12-665-2165 FAX: 27-12-665-2186 URL: www. d -link. co. za Russia Grafsky per. , 14, floor 6 Moscow 129626 Russia TEL: 7-095-744-0099 FAX: 7-095-744-0099 #350 URL: www. dlink. ru China No. 202, C1 Building, Huitong Office Park, No. 71, Jianguo Road, Chaoyang District, Beijing, 100025, China TEL +86 -10-58635800 FAX: +86-10-58635799 URL: www. dlink. com. cn Taiwan No. Neihu District Taipei City 114 Taiwan TEL: 886-2-6600-0123 FAX: 886-2-6600-1188 URL: www. dlinktw. com. tw D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Registration Card (All Countries and Regions excluding USA) Print, type or use block letters. [. . . ]