User manual D-LINK DI-514

[. . . ] D-Link Air DI-514 2. 4GHz Wireless Router Manual Building Networks for People Contents 1. Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Wireless Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If inconsistent data flow is a problem, only a minor modification should be made. Fragmentation - This value should also remain at its default setting of 2346. If you experience a high packet error rate, you may slightly increase your Fragmentation Threshold within the value range of 256 to 2, 346. Setting the Fragmentation Threshold too low may result in poor performance. DTIM - (Delivery Traffic Indication Message) 3 is the default setting. A DTIM is a countdown informing clients of the next window for listening to broadcast and multicast messages. Default is 1-2-5. 5-11Mbps. 28 TX Rates ­ Select the data rate. Preamble Type - Short preamble is the default setting. (High traffic networks should use the shorter preamble type. ) The preamble defines the length of the CRC block used in communication between the Access Point and the roaming wireless Network adapters. (Cyclic Redundancy Check is a common technique for detecting data transmission errors) Authentication - Select Open system, Shared Key or Auto Open System - The DI-514 will be visible to all devices on the network. Shared Key - In this mode, in order to access the DI-514 on the network, the device must be listed in the MAC Address Control List. Auto - In this mode, all devices on the network can access the DI-514. SSID Broadcast - Enable is the default setting. Choose Enable to broadcast the SSID across the network. All devices on a network must share the same SSID (Service Set Identifier) to establish communication. Choose Disable if you do not wish to broadcast the SSID over the network. Tools > Admin Admin At this page, the DI-514 administrator can change the system password. There are two accounts that can access the Broadband Router's WebManagement interface. Admin has read/write access while user has read-only access. User can only view the settings but cannot make any changes. Remote Management Remote Management allows the DI-514 to be configured from the Internet by a web browser. A username and password is still required to access the Web-Management interface. In general, only a member of your network can 29 browse the built-in web pages to perform "Administrator" tasks. [. . . ] Some states do not allow exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the foregoing limitations and exclusions may not apply. This limited warranty provides specific legal rights and the product owner may also have other rights which vary from state to state. Trademarks: D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks or registered trademarks are the property of their respective manufacturers or owners. [. . . ]