User manual D-LINK SMARTPRO DGS-1500-28

[. . . ] 107 iv About This Guide D-Link Web Smart Switch User Manual About This Guide This guide provides instructions to install the D-Link Gigabit SmartPro Switch DGS-1500-20/28/28P/52, how to use the SmartConsole Utility, and to configure Web-based Management step-by-step. Note: The model you have purchased may appear slightly different from the illustrations shown in the document. Refer to the Product Instruction and Technical Specification sections for detailed information about your switch, its components, network connections, and technical specifications. This guide is mainly divided into four parts: 1. [. . . ] For the receiving of LLDP packets, the switch will learn the information from the LLDP packets advertised from the neighbor in the neighbor table. click Apply to make the change effective. Message TX Hold Multiplier (2-10): This parameter is a multiplier that determines the actual TTL value used in an LLDPDU. Message TX Interval (5-32768): This parameter indicates the interval at which LLDP frames are transmitted on behalf of this LLDP agent. LLDP ReInit Delay (1-10): This parameter indicates the amount of delay from the time adminStatus becomes "disabled" until re-initialization is attempted. LLDP TX Delay (1-8192): This parameter indicates the delay between successive LLDP frame transmissions initiated by value or status changes in the LLDP local systems MIB. The value for txDelay is set by the following range formula: 1 < txDelay < (0. 57 –L2 Functions> LLDP > LLDP Port Settings From Port/ To Port: A consecutive group of ports may be configured starting with the selected port. Notification State: Specifies whether notification is sent when an LLDP topology change occurs on the port. The possible field values are: Enabled – Enables LLDP notification on the port. disabled – Disables LLDP notification on the port. Admin Status: Specifies the LLDP transmission mode on the port. The possible field values are: TX_Only – Enables transmitting LLDP packets only. 51 5 Configuration D-Link Web Smart Switch User Manual Disabled – Disables LLDP on the port. Port Description: Specifies whether the Port Description TLV is enabled on the port. The possible field values are: Enabled – Enables the Port Description TLV on the port. Disabled – Disables the Port Description TLV on the port. System Name: Specifies whether the System Name TLV is enabled on the port. The possible field values are: Enabled – Enables the System Name TLV on the port. Disabled – Disables the System Name TLV on the port. System Description: Specifies whether the System Description TLV is enabled on the port. The possible field values are: Enabled – Enables the System Description TLV on the port. [. . . ] Config account admin password Purpose Syntax Description Parameters Restrictions Example usage: To configure the account admin password: DGS-1500-28> config account admin password 1234 DGS-1500-28> To display the configuration of an IP interface on the Switch. C onfig ac c ount admin pas s word The c onfig ac c ount admin pas s word command sets the administrator password. <passwd> − The new password of the administrator. Save Purpose Syntax To save changes in the Switch’s configuration to non-volatile RAM. [. . . ]