User manual DA-LITE CABINET

[. . . ] The POWER In PRESENTATION PRODUCTS Instruction Book for DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574/267-8101 800-622-3737 Fax: 574/267-7804 http:// www. da-lite. com e-mail: info@da-lite. com CABINET Tools Required Electric Drill Masonry Bit 5/16" (if mounting in solid masonry or concrete) Screw Driver, #2 Flat Tip (if using toggle bolts) or #2 Phillips (if mounting in solid masonry or concrete) Hardware Provided 4 "V" Bars (two are factory mounted to back of cabinet; two will be mounted to wall) Toggle Bolts, 43/16" Lead Shields, #10­14 x 11/2" Phillips Flat Head Wood Screws, #10 x 2" 12 12 12 Adjustment Knobs On Four Corners Height of Wall Cabinet Back Of Cabinet 5" "V" Bar Mounted To Wall 41" (29" for 24"x36" only) Determine Measurement To Bottom Of Wall Cabinet Floor Wall "V" Bar Mounted To The Back Of The Wall Cabinet At The Factory INSTALLATION INSTRUCTIONS Determine the height of the top of the cabinet from the floor. Next use the above diagram to determine the placement of the top wall mounted "V" bar. Hold a loose "V" bar to the wall at the height determined above (MAKE SURE IT IS LEVEL), and mark the locations for the screw holes. [. . . ] Open and close the doors to confirm proper operation. FOR DELUXE CABINETS ONLY: To extend the easel, grasp the center of the panel along the lower edge, and pull outward. When the panel reaches its fully extended position, it will lock automatically. To return the panel to the cabinet, press the small lever found along the right edge of the panel. The telescoping easel is ready to receive paper pad chart clamps. This allows the user to use a paper pad flip chart on this panel and to flip used pages over the back of the easel. It is also possible to use multiple flip charts stacked by using accessory grip quick chart clamp 28" gold Da-Lite part number 72053. To use the projection screen swing the projection screen bar (located at the top, center of the cabinet) out. Open the cabinet door covering the screen (at the bottom of the cabinet), pull the screen up and slip it over the screen bar. The screen bar has multiple notches to allow for keystone elimination. ACCESSORIES MAGIC PANELS These panels are standard on the Deluxe cabinet and optional on the standard cabinets. Magic Panels are loop velcro fabric over cork with a durable black nylon frame. They can be used as tackboards or with hook velcro they can be used to display charts, photos, etc. These are sold in pairs using Da-Lite part numbers listed below: DA-LITE CABINET SIZE NUMBER 24" x 36" 48" x 48" 60" x 48" 72" x 48" PAPER PADS: All Da-Lite cabinets have two clamps on the doors to hold paper pads (except the 24" x 36" which only has one). The following chart shows which paper pads can be used with which cabinets: CABINET SIZE 24" X 36" 48" X 48" 60" x 48" DA-LITE NUMBER 43302 43302 43303 43306 43308 43303 43306 43308 67478 67479 67480 67480 WHITEBOARD MAINTENANCE Periodically clean the board with Da-Lite whiteboard cleaner. Interim cleaning may be done by sprinkling a dry powdered cleanser on an eraser and apply to the board in a circular motion. [. . . ] Gently remove the screen from its mounting brackets and roll up the extra fabric. Return the fabric to the cabinet and reinstall it into its brackets. NOTE: The arrow on the square tab end of the roller must be pointed up. 2 Printed in U. S. A. 77102 Rev. [. . . ]