User manual DA-LITE CINEMA CONTOUR SCREEN

[. . . ] This will ensure the snap pattern on the frame and screen surface will match. Attach the eight snap studs to the back of the frame in the predrilled holes. 1 SCREWS SNAPS FIGURE 1 (REAR VIEW) INSTALLATION There are four methods of installation based on the size of the screen and type of viewing surface. Measure the width of the viewing area of your screen and refer to the appropriate method of installation below. The wall bracket diagram shows the type and quantity of bracket(s) supplied based on the size of the screen. [. . . ] The viewing side is rolled to the inside of the roll. Place the frame over the screen surface, and while lifting the frame with one hand, snap the screen surface onto the frame with the other hand while maintaining a steady pull on the surface. Hang the screen on the brackets by hooking the bottom of the frame onto the lower wall bracket and lift up until you can hook the top of the frame on the top bracket. Push down on the frame to seat it on the brackets. Refer to Figure 4. LARGE WALL BRACKET 1-PIECE FIGURE 2 SMALL WALL BRACKET 1-PIECE LARGE WALL BRACKET OVERALL HEIGHT OVERALL HEIGHT LESS 1-3/8" 6" SMALL WALL BRACKET FIGURE 3 2 WALL METHOD 2 (SCREENS OVER 80" UP TO 96" IN VIEWING WIDTH) 1. Secure the wall bracket to wall studs at the desired height. The top of the frame will be 1/8" above the top of the wall bracket when mounted. You will need at least 5/8" clearance above the bracket to hang the screen. Figure 5 and 6 show the proper orientation for the supplied wall brackets. FIGURE 5 METHOD 3 (SCREENS OVER 96" IN VIEWING WIDTH) 1. Secure the wall brackets to wall studs at the desired height. The top of the frame will be 1/8" above the top of the wall bracket when mounted. You will need at least 5/8" clearance above the bracket to hang the screen. Figure 6 and 7 show the proper orientation for the supplied wall brackets. LARGE WALL BRACKET 2-PIECES LARGE WALL BRACKETS 3-PIECES HIGH POWER® BRACKET FOR LARGE SPLIT FRAMES ONLY. To install the bottom large wall bracket, you must measure the overall height of the screen frame and subtract 1/4". This is the dimension from the top of the upper wall bracket to the bottom of the lower wall bracket. Some large screen sizes (240") are made with 2piece side frame rails. For this type of frame you will need to attach one High Power® bracket to each side at the joint. The viewing side is rolled to the inside of the roll. Place the frame over the screen surface, and while lifting the frame with one hand, snap the screen surface onto the frame with the other hand while maintaining a steady pull on the surface. [. . . ] Using a dry 100% cotton cloth, wipe dry after each cleaning session. To clean a stubborn stain or a sticky surface, use denatured alcohol (methanol or methyl alcohol) following the same procedure as for water. LARGE WALL BRACKET 1-PIECE #10 SCREWS 4-PIECES HIGH POWER® BRACKET 2-PIECES FIGURE 8 2. Attach two High Power® brackets to the bottom frame rail as shown in Figure 8. The viewing side is rolled to the inside of the roll. [. . . ]