User manual DA-LITE DA-SNAP SCREEN

[. . . ] REAR VIEW 1 INSTALLATION There are four methods of installation based on the size of the screen and type of viewing surface. Measure the width of the viewing area of your screen and refer to the appropriate method of installation below. The wall bracket diagram shows the type and quantity of bracket that is supplied based on the size of the screen. Method 1: Screens 80" and smaller in viewing width. [. . . ] To install the small wall bracket, you must measure the overall height of the screen frame and subtract 1-3/8". Using that dimension, measure down from the top edge of the large wall bracket and mark the wall for two screw holes. The holes should be centered within the frame and 6" apart. Refer to Figure 3. 2 WALL FRAME BRACKETS 3-PIECES METHOD 2 (SCREENS OVER 80" UP TO 96" IN VIEWING WIDTH) 1. Use the supplied #10 screws to attach four frame brackets to the back of the frame as shown in Figure 5. FRAME BRACKETS 4-PIECES 5. Position the screen with the attached surface onto the top wall bracket as shown in Figure 7. Push down at the center of the bottom frame rail to hook onto the lower wall bracket. 1 LARGE WALL BRACKET 2-PIECES FIGURE 7 FIGURE 5 2. Secure the wall bracket to wall studs at the desired height. The top of the frame will be 1/8" above the top of the wall bracket when mounted. You will need at least 5/8" clearance above the bracket to hang the screen. To install the lower wall bracket, you must measure the overall height of the screen frame and subtract 1/4". This is the dimension from the top of the upper wall bracket to the bottom of the lower wall bracket. FIGURE 6 2 OVERALL HEIGHT WALL OVERALL HEIGHT -1/4" 4. The viewing side is rolled to the inside of the roll. Place the frame over the screen surface, and while lifting the frame with one hand, snap the screen surface onto the frame with the other hand while maintaining a steady pull on the surface. 3 WALL #10 SCREWS 8-PIECES METHOD 3 (SCREENS OVER 96" IN VIEWING WIDTH) 1. Use the supplied #10 screws to attach six frame brackets to the back of the frame as shown in Figure 8. Secure the wall brackets to wall studs at the desired height. The top of the frame will be 1/8" above the top of the wall bracket when mounted. You will need at least 5/8" clearance above the bracket to hang the screen. To install the lower wall bracket, you must measure the overall height of the screen frame and subtract 1/4". [. . . ] Mark the screw holes for the bottom brackets. Drill holes in wall and attach the brackets to the wall with screws. LARGE WALL BRACKETS 3-PIECES #10 SCREWS 12-PIECES FIGURE 8 5. The viewing side is rolled to the inside of the roll. Place the frame over the screen surface, and while lifting the frame with one hand, snap the screen surface onto the frame with the other hand while maintaining a steady pull on the surface. [. . . ]