Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual DA-LITE DESIGNER CINEMA. We hope that this DA-LITE DESIGNER CINEMA user guide will be useful to you.
Lastmanuals help download the user guide DA-LITE DESIGNER CINEMA.
Manual abstract: user guide DA-LITE DESIGNER CINEMA
Detailed instructions for use are in the User's Guide.
[. . . ] There are three ways to install the Designer Cinema: Wall Mount, Ceiling Mount, or Ceiling Hook. Procedures for each method are as follows: Wall Mount 1. Secure the wall mount bracket to the wall at the desired height. Bracket should be fastened to wall studs or some reinforcement within the wall. [. . . ] Do not remove the wall mount bracket, even if you are not using it for mounting. This provides structural stability to the case. Be sure the ceiling has adequate reinforcement to attach a hook anchor. The top of the screen case has a channel that the ceiling hook brackets slide into. Remove the end cap on the right end of the case and insert the brackets into the case channel. Lock the brackets in place by tightening two set screws. The brackets can be attached anywhere within 12" of the end of the case. Attach an S-hook or similar fastener to the large center hole on the bracket.
SET SCREWS (2) HOOK MOUNT HOLE
ENDCAP SCREWS (3) ENDCAP
FIGURE 3
SCREEN ADJUSTMENT
Screen travel is stopped automatically in the down and up positions by the limit switches that are preset at the factory. If it's necessary to adjust for more or less drop follow the steps below. The case cover must be removed to access the motor limit switches. Remove the case cover screw from both ends of the screen. Be sure to hold the cover while removing the screws. Rotate the cover up and away from the case until it can be removed. SETTING THE DOWN LIMIT POSITION TO REDUCE SCREEN DROP: Turn the red limit switch screw clockwise to decrease the amount of screen drop. Run the screen down to test the stop position. If the screen drops too far, raise the screen about one foot and adjust the limit switch again. Repeat until the desired position is set. TO INCREASE SCREEN DROP: Turn the red limit switch screw counterclockwise to increase the amount of screen drop. Run the screen down to test the stop position. If the screen does not drop enough, raise the screen about one foot and adjust the limit switch again. [. . . ] (b) "Down" limit switch out of adjustment 3. Incorrect stopping position in upward direction. (b) "Up" limit switch out of adjustment 4. NOTE: Screen will operate with a low pitched hum. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DA-LITE DESIGNER CINEMA
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual DA-LITE DESIGNER CINEMA will begin.
