User manual DA-LITE MPS-ACM

[. . . ] Automated Confidence Monitor Stand MPS-ACM Form E-443 Rev. 11 / 08 Caution: The user of this product should exercise caution when moving the Automated Confidence Monitor Stand. [. . . ] To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized service dealer when repair work is required. Incorrect reassembly can cause electric shock when the appliance is used subsequently. The use of an accessory attachment not recommended by the manufacturer may cause a risk of fire, electric shock, or injury to persons. SAVE THESE INSTRUCTIONS Required Tools: Procedure 1. Remove contents from carton and examine for damaged or missing parts. 7/16" wrench 9/16" wrench 3/16" allen wrench Phillips screwdriver 1 2 3 8 4 5 9 6 7 10 12 11 2. Insert tube enclosures shown in Figure 1. Insert two Columns into the Base and install the fasteners shown. Leave loose at this time. A G Figure 1 KNOBS TO HOLD POSITION 5. Slide the Top Assembly down the Columns. Position the Top by tightening both Knobs. Tighten the fasteners at the bottom of the Columns. Attach the Links to the outside of the Zee Bar Assembly. F LINK C Figure 3 9. Mount the Hanging Brackets to the back of the Plasma Unit utilizing all the fastener points recommended by the plasma manufacturer. [. . . ] See Figure 8. E Figure 7 Figure 8 B 16. Install fasteners into top of Columns for theft deterrent. D Figure 9 [. . . ]