User manual DA-LITE PERM WALL FRAME

[. . . ] The POWER In PRESENTATION PRODUCTS Installation Instructions for DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 Toll Free Fax: 877-325-4832 www. da-lite. com e-mail: info@da-lite. com PERM WALL FRAME PERM WALL INSTALLATION The Perm Wall frame should be fastened to a wall. [. . . ] Drill through aluminum tubing every 18" to 24" and fasten to wall with appropriate fastener (not supplied) for type of wall construction. NOTE: Use appropriate fastener for wall construction, i. e. wood screws if wall behind frame is wood construction or other appropriate fastener if dry wall or plaster or cement block construction. Make sure that sides are at 90 degrees or right angle to bottom and fasten to wall in like manner. Next fasten top of frame to wall in the same manner, making sure that the center is the same distance from the bottom as it is at the sides of frame. This is most important for proper surface fit. NOTE: If a center spreader is shipped with frame, insert center spreader between the bottom and the top of frame as a guide. This is most important to insure that the top and bottom are equal distance apart across the entire top of frame. [. . . ] To clean a stubborn stain or a sticky surface, use denatured alcohol (methanol or methyl alcohol) following the same procedure as for water. DETAIL VIEW OF FRAME CORNER CORNER PLASTIC BRACKET FRAME TUBING #12 SHEET METAL SCREW PRECISELY PLACED STUDS FOR SNAP BUTTONS COLOR CODED BANDS TO SIMPLIFY ASSEMBLY (FOR LARGE SCREENS WITH WIDTH 96" AND OVER) ANODIZED ALUMINUM FRAME DETAIL VIEW OF FRAME JOINT PICTURE SURFACE STEEL BRACKET WING NUT CONCEALED BY BINDING BINDING WITH SNAP BUTTONS FRAME TUBING Printed in U. S. A. 1 76087 Rev. [. . . ]