User manual DA-LITE PM7UL-47JF

[. . . ] With the assembly on its side, slide the middle shelf inside the lower legs to its proper position. The PM7UL47JF may be assembled to be 45" or 47" tall. Determine which height you need and fasten the upper legs to the lower legs and middle shelf with two screws and nuts per corner. Figure 2 14 R 9 13 2 HOLE SIDE 4. [. . . ] With the assembly on its side, slide the middle shelf inside of the legs to its proper position. Make certain the two holes of the shelf are on the left. Fasten the middle shelf to the legs with two screws and nuts per corner. Place the top shelf inside of the legs and fasten with two screws and nuts per corner. Make certain the two holes of the shelf are on the left. Leave fasteners loose at this time. Figure 3 X R 5. Insert Casters into caster sockets and stand cart upright on hard flat surface. Push down or lightly tap on high corners to correct rocking. Tighten all fasteners. 2 HOLE SIDE 11 8 11 6 F V W 5 6. Assemble the Columns and Mount Support Bracket to the top shelf. The Sliding Nuts go into the slots of the Columns. Therefore, the slots of the Columns must face each other. Adjust height of Bracket and tighten fasteners. Attach the Mount to the Mount Support Bracket. The Mount may be tilted using the fasteners shown, however, secure Mount in the vertical position at this time. C 3 T Figure 5 8. Secure the Hanging Brackets to the back of the flat panel display utilizing all of the fastener points recommended by the flat panel manufacturer. See Figure 6. Note: It is the responsibility of the installer to obtain any additional fasteners needed to secure the hanging brackets to the flat panel unit. Figure 6 1 P R 9. Hang the flat panel display on the Mount making certain the top and bottom notches on each Hanging Bracket are placed over the upper and lower Zee-Bars. 8 ZEE-BAR Q Figure 7 TILT CONTROLLING 3/8" FASTENER 4 PLACES 10. Slide the Security Bar through the slots in the Hanging Brackets and Mount, bolt one end to the Zee Bar and then secure the opposite end with the padlock. Use extreme caution if you must adjust the height with the flat panel display in place. Tighten all fasteners. U 4 7 Figure 9 SAFETY GUIDELINES The PM8UL-44F will provide the safest transportation of flat panel monitors when the following guidelines are met. [. . . ] 8 ZEE-BAR Q Figure 7 TILT CONTROLLING 3/8" FASTENER 4 PLACES 10. Slide the Security Bar through the slots in the Hanging Brackets and Mount, bolt one end to the Zee Bar and then secure the opposite end with the padlock. Use extreme caution if you must adjust the height with the flat panel display in place. Tighten all fasteners. V 4 Figure 9 7 SAFETY GUIDELINES The PM10UL-44F will provide the safest transportation of flat panel monitors when the following guidelines are met. [. . . ]