User manual DA-LITE TENSIONED COSMOPOLITAN ELECTROL

[. . . ] Remove shipping brackets by removing the screws from the slat bar and wooden board. Always handle screen in horizontal position. INSTALLATION There are three methods of mounting to include: Flush against wall; Suspended from ceiling (use extension brackets); and Recessed above ceiling. CONCEALED (ALLOW ROOM FOR ACCESS) WALL MOUNTED CEILING MOUNTED PICTURE SURFACE PICTURE SURFACE PICTURE SURFACE USE No. 6 BRACKETS TO HANG BEHIND BEAM OR VALANCE PICTURE SURFACE FIG. 1 NOTE: Under no circumstances should unit be completely sealed in recessed installation. [. . . ] Run the screen down to test the stop position. If the screen does not drop enough, raise the screen about one foot and adjust the limit switch again. Repeat until the desired position is set. !s CAUTION: Do not adjust for more drop than what was ordered. At least 1-1/2 wraps of fabric must remain on the roller. This screen comes standard with 12" black at the top. NOTE: The slat bar will not retract completely into the case. DO NOT adjust the up limit travel any higher than the factory preset position or damage may occur. 4 SCREEN ADJUSTMENT FOR 120V SCREENS WITH A BUILT-IN LOW VOLTAGE CONTROL OR VPI 1. Locate the wall switch and remove the cover plate from the 3-button wall switch and remove the switch from the junction box. Locate the two tactile buttons on the back of the switch. They are square silver with black round buttons. See Figure 4 (VPI) or Figure 5 (LVC) for diagram. To adjust the down limit switch, press and hold the down tactile button until the LED on back of switch turns solid red. This will put the motor in limit set mode. Turn the wall switch over and use the down button on front of switch. Press and hold until the desired travel position is reached. If you travel to far down you can press the up to move the screen upward. If you press and let go of either up or down button the motor will do a small jog in that direction for finer adjustment of screen. Once desired position is reached turn switch over press and hold down tactile button until the LED on back of switch blinks red twice. To adjust the up limit switch, press and hold the up tactile button until the LED on back of switch turns solid green. This will put the motor in limit set mode. Turn the wall switch over and use the up button on front of switch. Press and hold until the desired travel position is reached. [. . . ] If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment. To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND MERCHANT ABILITY. Any implied warranties of fitness for use, or merchantability, that may be mandated by statute or rule of law are limited to the one (1) year warranty period. [. . . ]