User manual DAEWOO DOC-090RH

[. . . ] How to Handle Water . . . . . . . . . . . . . . . . . . . . . . . . . . . . Absolute Precaution in Use . . . . . . . . . . . . . . . . . . . . . . 11 Absolute Precaution in Use . . . . . . . . . . . . . . . . . . . . . . 12 Points to be Rechecked before Determine any Troubles. . . . . . . . . . . . . [. . . ] Up to date Slim Design Contemporary design of slim and simple, which emphasized on the color in order to coordinate with indoor atmosphere. - 3- The Name of Each Part Front Opening for cooling & heating Back Filter cover Vertical air- flow control lever Plug Inhaling opening Handle Cord holder Ventilating opening Caster Water- tank Remote controller Duct kits ON/OFF ON/OFF MODE FAN MODE FAN TEMP Duct holder B TIMER SWING TIMER TEMP SWING OPTION Duct Duct holder A Support board - 4- Control Panel and Functions Control Panel POWER S/W Air conditioner will start by pushing ON/ OFF switch in the sequence of air cleaning. For switching off, push ON/ OFF switch again. MODE S/W Selecting the functions of different modes by pushing the switch in order of Air Cleaning( ), Air Conditioning( ), Dehumidifying( ), Heating( ). ¥° ¥± ¥² FAN S/W Selecting the speed of fan in order of mild( ), medium( ), maximum( ). SWING S/W When the switch is ON, the inside picture will move horizontally and the cool air will be supplied evenly in the room. For switching off, push the button once again. TIMER S/W Setting operation time from 1 hour to 8 hours. For continuous operation, push the switch until the lamp is off. TEMP S/W It has 4 different phases. Use remote controller for selection of desired temperature. FULL LAMP When the water container is full, the beefer will signal for 5 consecutive times and the lamp will be on. When the empty water container is replaced, the lamp will be off and the air conditioner will automatically resume its function. - 5- HOW TO SET-UP AND HANDLE 1. Installation of Duct 1. Fix the duct supporting board on window pane as shown below. If the length of duct supporting board is short vertically, it can be adjusted by pulling 2nd supporting board as shown in figure B. Fix the duct and fitting B, and push them out through the duct supporting board as shown below. Duct fitting B Figure A Figure B 3. Push the duct fitting A into the duct hole of main body as shown below 4. When the installation of duct is finished, turn the air conditioner on by switch or remote controller. Duct fitting A 2. For moving the air conditioner, hold the handles on both side and move it to the desired place. - 6- INSTRUCTION I * Before starting air conditioner, see to it that the appliance is properly placed and all doors and windows are closed intact. 1. See to it that the water container is properly placed. Select MODE switch on air conditioning(T ) and select desired temperature. 5. When the water container is full, the beefer will signal and the warning lamp will blink simultaneously, and then water container should be emptied. (See page 10) - 7- INSTRUCTION II * Before starting air conditioner, see to it that the appliance is properly placed and all doors and windows are closed intact. 2. Dehumidifying Set the dehumidifying Mode switch on Dehumidify( S). When the water container is full, the beefer will signal and the warning lamp will blink simultaneously, and then water container should be emptied. Air Fan Set the Mode switch on Fan( ). 4. Heating Set the Mode switch on Heating( ). * Ambient temperature for air conditioning and dehumidifying is 18 C- 35 C. When the ambient temperature is below 18 C, the compressor will not function and the temperature lamp will blink simultaneously while the fan will start for removing the frost. * When the function of air conditioning and dehumidifying is stopped, it will not operate for approximately 3 minutes in order to prevent overload of compressor; but it will be fanning for approximately 3 minutes, and then both air conditioning and dehumidifying will start again. - 8- HOW TO CLEAN AND HANDLE THE FILTER * When the filter is contaminated with dust, clean the filter once in every 2 weeks, lest it should decrease the fanning function. 1. Remove the filter by pulling toward the arrows shown below. 3. Clean the filter in a neutral detergent dissolved water (appr. 30¡£ C) and dry well in the shadow. 4. Outside Clean the outside with wet soft cloth soaked in neutral detergent dissolved water, and then dry it with a clean soft cloth thoroughly until the neutral detergent is completely removed. * When handling and cleaning the filter as directed above, see to it that the power connector is disconnected. * When the evaporator is contaminated with dust, the efficiency of air conditioning will be decreased. [. . . ] Are still charged batteries in the remote control?Is the time setting expired? Has 3minutes been passed to restart the product?Isn't the temperature of the room below 64. 4 F?Is the connection of plug and outlet too loose? [. . . ]