User manual DAEWOO DPB-540RH

[. . . ] Button and Indicator Press to select left/right direction for fan. 8 ON/OFF Button and Indicator Press to turn the unit on or off 9 Remote Sensor 10 TEMPERATURE & RESERVATION TIME Indicator NOTE: · Heat mode is available on the only heat pump model. 3 REMOTE CONTROLLER AUTO SWING FAN DIR. Button Press to select up/down direction for fan. FAN DIR. FAN DIR. FAN DIR. Button Press to select left/right direction for fan. LOCK Button In case that the Lock option is applied, other buttons on the indoor unit don't work. To cancel the Lock option, press any botton on the remote controller. [. . . ] (Cool ¡æFan ¡æHeat) · Outdoor unit operation indicator gets lit on and the Heat mode starts, with 3 minutes' delay after the Heat mode indicator is lit on. · To stop the Heat mode, press the on/off button and all functions stop. COOL . . . ^, , FAN ¿ HEAT . . . ­¯^ Setting Temperature(ex. In case that desired temperature is 23) CURRENT TEMP DESIRED TEMP UP DOWN · With the¦k button pressed, temperature goes up by 1°C and with the button pressed, temperature goes down by 1°C. · You can freely set your desired temperature, ranging from 16 to 32°C. · In case that your desired temperature is lower than the current temperature, the Heat mode isn't working. 8 k¦ CURRENT TEMP DESIRED TEMP FAN SPEED · Press the Fan Speed button. · At the outset of operation, the Fan Speed is set on 'High' · By pressing the Fan Speed button during Heat or Cool mode, you can change the speed High, Middle, Low, Auto in order. (During the Fan mode, the speed changes High, Middle, Low in order. LO. AUTO FAN DIRECTION · Press the Fan Dir. · At the outset of operation, the direction is fixed. · To set the direction left/right, press the Fan Dir button to start and press the button again to stop it. · To set the direction up/down, press the Fan Dir button to start and press the button again to stop it. · To set the direction both up/down and left/right, press button and FAN DIR. button. 9 TURN - OFF TIMER: available during operation only (ex. In case of setting the timer to turn off the air-conditioner in 5 hours. ) · During operation CURRENT TEMP DESIRED TEMP · Press the Timer on/off button. · "1hr" is shown. TIMER ¿, , CURRENT TEMP DESIRED TEMP OFF TIMER · Press the¦k button to set "5 hr". CURRENT TEMP DESIRED TEMP UP DOWN OFF TIMER · Press the Timer on/off button. · Timer indicator gets lit on and the Temperature & Reservation Time TIMER ¿, , indicator shows the current temperature. · Reservation time is set by 1hr unit. · To check the reservation time, press the Timer on/off button. · When the Turn-off time is due, the operation stops automatically. CURRENT TEMP DESIRED TEMP OFF TIMER TO CANCEL THE TIMER §sTo cancel the Turn-off Timer, press the Timer On/Off button twice in a row. TO CHANGE THE RESERVATION §s Cancel the reservation and apply the same procedure of Turn-off Timer. TIMER ¿, , · You can cancel the Timer only in case that the reservation time is already set. 10 TURN -ON TIMER: available during non-operation only (ex. In case of setting the timer to turn on the air-conditioner in 2 hours. ) · During operation. CURRENT TEMP DESIRED TEMP · Press the Timer on/off button. · "1hr" is marked. CURRENT TEMP DESIRED TEMP TIMER ¿, , TIMER ON · Press the ¦k button to set "2 hr". CURRENT TEMP DESIRED TEMP UP DOWN TIMER ON · Press the Timer on/off button. This is due to the protecting device delaying the operation of outdoor unit for 3 minutes for the protection of compressor and the air cooling current will blow out automatically after 3 minutes' delay. ¡Ü In case that the power is resupplied. Reoperation after power failure. Select the functions all again in case that the power is resupplied after the main power supply switch gets turned off or power goes off. ¡Ü Little noise and neat appearance. Antibacterial function and excellent air cooling system for more pleasant Other Merits atmosphere. Self-operating of Fan Direction with up/down and left/right. [. . . ] There is an obstacle in front of intake or indoor unit. The temperature has been set improperly. Clean or replace filter(s). When locating unit for the first time, make sure it is in a desirable location. Check and reset if necessary This is normal. Strange sounds occur. During operation, especially after turning it on or off, refrigerant flows inside the unit. [. . . ]