User manual DAEWOO DSB-123L

[. . . ] SAFETY INSTRUCTIONS PLEASE READ THE FOLLOWING SAFETY INSTRUCTIONS BEFORE INSTALLING AND OPERATING THE UNIT: This air conditioner meets strict safety and operating standards. The installer of this unit must install or service this unit so it operates safely and efficiently. Precautions When Wiring: Do not plug in the unit until all connections (tubing, drain hose, mounting, etc. ) have been made and double-checked. High voltages are present in this unit and are very dangerous. Please refer to these instructions and diagrams when wiring. [. . . ] Slide down further to access the battery compartment. Insert two "AAA" size Alkaline batteries following the polarity diagram below. TIMER ON/OFF ENTER/ CANCEL TURBO/MILD + BATTERY PRECAUTIONS The precautions below should be followed when using batteries in this device: 1. Use only the size and type of batteries specified. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. Do not mix different types of batteries together (e. g. Alkaline and Carbon-zinc) or old batteries with fresh ones. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer's directions). CELSIUS TO FAHRENHEIT CONVERSION CHART CELSIUS 18 19 20 21 22 23 24 25 FAHRENHEIT 64. 4 66. 2 68 69. 8 71. 6 73. 4 75. 2 77 CELSIUS 26 27 28 29 30 31 32 FAHRENHEIT 78. 8 80. 6 82. 4 84. 2 86 87. 8 89. 6 NOTES: When operating the remote controller, make sure there are no obstructions between the remote controller and the remote sensor. After a while the display goes blank to conserve battery power. To check the settings, press the ON/OFF button once. 11 + DSB-123L/LH/AH/123PH/F123L 2003. 3. 4 1:56 PM 12 TO SET AUTO MODE This unit will automatically operate the unit according to its surroundings while in the Auto mode. All you have to set is the desired temperature and it will control the fan, coolness and dehumidifier. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. Make sure the AUTO indicator AUTO appears in the remote display. or buttons, set the desired temperature. The desired temperature can be changed up or down 1 degree from the actual room temperature. Then the unit will automatically operate. AUTO TO SET QUICK MODE To set this unit to cool at the highest power, follow the procedures below: 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. Press the MODE button until the Quick indicator appears in the display. 3. The unit will then start cooling the room at the highest power. TO SET COOL MODE To set the unit to cool the room to a desired temperature, follow the procedures below: 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. [. . . ] NEVER USE Solvents, harsh chemicals or hot water to clean the unit. Some metal edges on the unit are sharp. Internal parts in the outdoor unit may need cleaning or routine maintenance from time to time. Consult your local service center for more details. AFTER THE SEASON: Operate the fan, then dry the indoor unit. [. . . ]