User manual DAEWOO DSB-182L [REVISION EDITION]

[. . . ] SAFETY INSTRUCTIONS PLEASE READ THE FOLLOWING SAFETY INSTRUCTIONS BEFORE INSTALLING AND OPERATING THE UNIT: This air conditioner meets strict safety and operating standards. The installer of this unit must install or service this unit so it operates safely and efficiently. Precautions When Wiring: · Do not plug in the unit until all connections (tubing, drain hose, mounting, etc. ) have been made and double-checked. · High voltages are present in this unit and are very dangerous. Please refer to these instructions and diagrams when wiring. [. . . ] Do not mix different types of batteries together (e. g. Alkaline and Carbon-zinc) or old batteries with fresh ones. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer's directions). SETTING THE UNIT FOR REMOTE OPERATION After the unit is fully connected and plugged in, it can be turned on. To turn the unit on and set it for remote operation, follow the procedures below: 1. Open the indoor unit's cover and make sure the EMERGENCY/REMOTE switch is set to the REMOTE position; this will allow the unit to operate with the remote controller. Press the ON/OFF button on the remote controller to turn on the unit. The On LED will light on the indoor unit and "ON" will light in the remote display. To select the various modes and settings, read the following pages. EMERGENCY/REMOTE Switch THREE MINUTE COMPRESSOR DELAY EMERGENCY REMOTE · After turning the indoor unit on and setting it for air conditioner operation, the compressor (outdoor unit) will not come on for three minutes. This is a feature that will protect the compressor from damage due to quick start and stops. 8 ­ + CELSIUS TO FAHRENHEIT CONVERSION CHART CELSIUS 18 19 20 21 22 23 24 25 FAHRENHEIT 64. 4 66. 2 68 69. 8 71. 6 73. 4 75. 2 77 CELSIUS 26 27 28 29 30 31 32 FAHRENHEIT 78. 8 80. 6 82. 4 84. 2 86 87. 8 89. 6 NOTES: · When operating the remote controller, make sure there are no obstructions between the remote controller and the remote sensor. · After a while the display goes blank to conserve battery power. To check the settings, press the ON/OFF button once. TO SET THE UNIT TO AUTO MODE This unit will automatically operate the unit according to its surroundings while in the Auto mode. All you have to set is the desired temperature and it will control the fan, coolness and dehumidifier. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. Make sure the AUTO indicator appears in the remote display. w or v buttons, set the desired temperature. The desired temperature can be changed up or down 1 degree from the actual room temperature. For temperature setting: 24~28°C 3. Then the unit will automatically operate. AUTO 9 TO OPERATE ONLY FAN To operate only the fan so the unit will circulate the air, proceed as follows: 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. Press the MODE button until the Fan indicator appears in the display. [. . . ] · Make sure the indoor unit's AC cord is not connected to AC power when performing these procedures. Clean the casing and front of the indoor unit with a vacuum brush or wipe with a clean damp cloth. · NEVER USE Solvents, harsh chemicals or hot water to clean the unit. · Some metal edges on the unit are sharp. · Internal parts in the outdoor unit may need cleaning or routine maintenance from time to time. [. . . ]