User manual DAEWOO DTC-2987

[. . . ] DTC-2987 CONTENTS SPECIFICATIONS IMPORTANT SAFEGUARDS AERIAL CONNECTIONS AV CONNECTIONS BATTERY INSTALLATION CONTROLS OPERATION OF CONTROLS TROUBLESHOOTING 1 2 3 4 6 7 9 19 SPECIFICATIONS TV Standard Mains Voltage Power Consumption Sound Output Power Channel Coverage PAL/SECAM-B/G, D/K, I, NTSC-3. 58/4. 43 110-250V~, 50/60 Hz 145W approx. 10% THD) VHF-L : I1-S8CH (43. 25-154. 25MHz) VHF-H : S9-S41CH (161. 25-463. 25MHz) UHF : C13-C57CH (471. 25-863. 25MHz) Tuning System Program No. Terminal Remote Control Unit Voltage Synthesizer Tuning System ON-Screen Display 100 Programmes AV input 1, 2. R-33 (Required two 1. 5V penlight batteries type with AA Size) Dimension Weight 699 x 558 x 499mm 45kg approx. 1 IMPORTANT SAFEGUARDS To operate your receiver at the peak performance, please read this Instruction Manual carefully and retain it for the future reference. [. . . ] COLOR Adjust the strength of the color as preferred. SHARPNESS This is used to change the sharpness degree of the picture. It is the most suitable when watching programmes from the external source such as a VCR. TINT; ONLY NTSC This is used to adjust tint of the NTSC color picture. B/B (BACK BLUE) When there is no signal and B/B is ON, the display is blue. In case B/B is OFF by pressing LEFT or RIGHT button, the noise signal will be appear on the screen. SOUND (SUB MENU) 1. BASS Place the cursor at BASS by using DOWN/UP buttons and adjust the sound of the low frequency band by SOUND MEMORY using LEFT/RIGHT buttons. BASS 70 |||||||||||| TREBLE 50 ||||||||| 2. TREBLE BALANCE 0 || Place the cursor at TREBLE and adjust it as BASS mode. It is used to adjust the high frequency band. BALANCE This is used to control the strength of left or right each SPEAKER by using LEFT/RIGHT buttons. 11 TIMER (SUB MENU) 1. CLOCK Place the cursor at CLOCK by using DOWN/UP buttons and the dash( - - ) of CLOCK mode will flicker. The CLOCK will be changed by pressing LEFT/RIGHT buttons. Press the ENTER button after setting the hour, the dash( - - ) of the minute will flicker. Continually pressing the ENTER button or DOWN/UP buttons after setting the minute like the hour, the cursor will be place at ON TIME or OFF TIME. If the MAIN POWER switch ( ) on the TV SET is turned off, it becomes initial mode. ON TIME ONCE ON TIME mode is changed as like OFF EVERY whenever LEFT/RIGHT buttons are pressed. After that, set ON TIME by using LEFT/RIGHT button like CLOCK mode. If ON TIME mode is OFF, then you can't set ON TIME. TIMER CLOCK ON TIME 09:00 ONCE 09:30 POS. and select the programme number by using LEFT/RIGHT buttons or PR SELECTION buttons 0-9. Then the TV will be always switched on with this programme automatically on setting time. OFF TIME Place the cursor at OFF TIME and set the time as ON TIME mode. [. . . ] SYSTEM CLOCK 17 SYSTEM This is used to switch the SYSTEM of the TV set. Press the SYSTEM button, then the SYSTEM will be SYSTEM displayed as shown in the right figure. The SYSTEM COLOR: AUTO consists of COLOR and SOUND. SOUND: B/G At first, the SYSTEM is preset to COLOR: AUTO, SOUND: B/G at the factory. [. . . ]