User manual DAEWOO DTR-20D7 annexe 1

[. . . ] Make sure that the polarity matches with the (+) and (-) marks inside of the battery compartment. Used batteries should be disposed properly. AERIAL CONNECTION For better picture and sound quality, an effective aerial installation is the most important. If you are located in a relatively strong area, you will be able to use the indoor aerial. When using an outdoor aerial, it is usually connected to the set by means of 75 ohm coaxial cable. MAINS CONNECTION Plug the mains cable into the power socket with 100-250V~, 50/60Hz. SWITCHING THE SET ON AND OFF Switching On Switch the set on with the MAIN POWER button in front of the receiver. [. . . ] The color of the PROGRAM OSD will be changed to the red when the program is in the skip state. o Preset o Manual V/W Auto Fine Tune V/W Station : P01 - - - - PO1 VHF1 ³³ o Preset o Manual V/W Auto Fine Tune V/W Station : P01 - - - - PO1 VHF1 ³³ o Preset o Manual V/W Auto Fine Tune V/W Station : P01 - - - - 5 DAILY USE SELECTING A PROGRAMME NUMBER The set has a total of 100 programme numbers, 0. . 99. The NUMBER buttons 0. . 9 are used for direct programme selection. In order to select two-digit programme, press the second numbered button within two seconds. Switch through the programme number step by step with the UP/DOWN buttons. VOLUME AND PICTURE CONTROL VOLUME CONTROL Adjust the volume with the VOLUME DOWN/UP buttons on the front of the set, or with the LEFT/RIGHT buttons on the remote control. *In the case you have a TV set with WOOFER function, if you want to hear bass-toned trembling sound which focuses on lower voice, in the main MENU move the cursor to WOOFER, press OK button and adjust the volume. MUTE Pressing the MUTE button once turns the sound off. The sound returns if the button is pressed once more or VOLUME key is pressed. NORMAL PICTURE SELECTION When you press the OK button repeatedly you can call up three picture settings: for NORMAL I(hard picture), NORMAL II(soft picture), FAVORITE (adjustable picture). PICTURE CONTROL Enter picture in the main menu. You can select each function with the UP/DOWN buttons. Use the LEFT/RIGHT buttons to adjust each function. Explanation about the each function will be displayed in the lower screen whenever you select the function. *Yon can set BB function ON/OFF by using LEFT/RIGHT buttons. If you set BB function ON, you can see the blue-colored screen when the TV receives no signal. *The TINT is active only in NTSC system. The last set value is automatically stored in FAVORITE mode. o Picture o 54 58 55 58 BB On 6 TIMER Enter TIMER in the MAIN MENU. SETTING THE CLOCK With the cursor located on the CLOCK using UP/DOWN buttons, move it to first digit line with RIGHT/LEFT buttons. You can adjust the time by selecting the proper digit with UP/DOWN buttons. The set time is memorized when you press the RIGHT button after you set the time. SETTING THE ON TIME First, with the cursor located on ON TIME, adjust the time. With the UP/DOWN buttons select the program you want. [. . . ] When you want to return to TV mode, if your current selection is VIDEO 1 you must press the AV button on the remote control unit or the TV/VIDEO button on the front mask twice which makes the mode go through VIDEO 2 to TV mode. If your current selection is VIDEO 2 you have to press the AV button on the remote control unit or the TV/VIDEO button on the front mask only one time to return to the TV mode NOTE 1. If you have a mono VCR, video disk player, video game or camcorder, connect the Audio out line of the external equipment to the L(MONO) socket of the TV AUDIO IN and the AUDIO IN line of the external equipment to the L(MONO) socket of the TV AUDIO OUT. The back AV JACK and SCART JACK are common. [. . . ]