User manual DAEWOO DTY-29G1 annexe 1

[. . . ] If you are located in a relatively strong area, you will be able to use the indoor aerial. When using an outdoor aerial, it is usually connected to the set by means of 75 ohm coaxial cable. 3 MAINS CONNECTION Plug the mains cable into the power socket with 230V 50Hz AC. SWITCHING THE SET ON AND OFF Switching On Switch the set on with the MAIN POWER button, ( ). If not, press either : - PR UP or DOWN button on the front of set - or POWER button or the UP/DOWN button or one of the NUMBER button 0. . 9 on the remote controller. The STAND-BY INDICATOR will turn off and a picture will appear on the screen. [. . . ] To do so, move the cursor to the right and press OK button. Using the UP/DOWN button, select the desired letter, number or blank. Press the RIGHT button to select the next position. Press the OK button to complete this procedure. TO STORE PROGRAMME IN MEMORY Move the cursor to the right end with the LEFT/RIGHT button. Select the programme number that you want to store current displaying programme with station name, fine tuning data using the UP/DOWN button or NUMBER 0. . 9. Press the OK button. PRESET P01 P SEARCH PRESET UHF >> P01 P FINE TUNE PRESET UHF >> P01 ---DRFS BBC1 BBC2 ITU CH4 PRESET P P01 BBC1 P PRESET P01 BBC1 P02 6 DAILY USE SELECTING A PROGRAMME NUMBER The set has a total of 70 programme numbers, 0. . 69. The NUMBER button 0. . 9 are used for direct programme selection. In order to select two-digit programm, press the second numbered button within two seconds. Switch through the programme number step by step with the UP/DOWN button. VOLUME, PICTURE AND SOUND CONTROL VOLUME CONTROL Adjust the volume with the VOLUME ( ) DOWN/UP buttons on the front of the set, or with the LEFT/RIGHT button on the remote control. MUTE Pressing the MUTE button ( ) once turns the sound off. The sound returns if the button is pressed once more or the programme no. NORMAL PICTURE SELECTION When you press the NORMAL button repeatedly you can call up three picture settings; for NORMAL I(hard picture), NORMAL II(soft picture), FAVORITE (adjustable picture). PICTURE CONTROL Press the MENU button to call up the MAIN MENU. Press the OK button to call up the PICTURE MENU. You can select each function with the UP/DOWN buttons. Use the LEFT/RIGHT button adjust each function: BRIGHTNESS( )-CONTRAST( )-COLOUR( -SHARPNESS( )-TINT( ). * The TINT is active only in NTSC system. The last set value is automatically stored in FAVORITE mode. Note that if you set the brightness and contrast values too low, the Onscreen-display become dark. SOUND CONTROL Press the MENU button to call up the MAIN MENU. Select the required function by moving the cursor with the DOWN or UP button. [. . . ] If not, press the AV button ( ) on the remote control or on the front of the set. The ( ) 1(AV1) will be displayed on the screen with the current programme number. In AV mode, you can change the TV programme number with the UP/DOWN button or the NUMBER button 0. . 9. Note that it's impossible to control the functions except the volume control and mute function in the RGB mode. [. . . ]