User manual DAEWOO DW-2520P

[. . . ] Hang the "U" shaped outlet of drain hose on the edge of a sink. · The opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor. WATER INLET OPERATING INSTRUCTIONS Preparing the Wash · Sort the clothes into groups-whites, colourfast, non-colourfast, delicates, lint free, lint producers, etc. , and wash according to the laundry guide. · Clothes with worn patches or tears should first be mended. Empty out all pockets and close all side fasteners. [. . . ] The spin basket will spin for the time selected, then stop(at position "0"). · To remove or reposition clothes during the spin dry cycle, open the outer and Caution: Ensure that the spin basket completely stops before reaching in to remove the wash load. inner door spin, In this case, the spin basket will automatically stop as a brake is supplied when the door spin outer is opened. · If there is any abnormal vibrating during spin drying, turn off the spin timer and rearrange the clothes uniformly inside the spin basket. Note: The pump motor will operate when the spin dry timer is set, irrespective of whether the outer lid is closed or opened. 4 `5 OPERATING INSTRUCTIONS Simultaneous Washing and Spin Drying · Three motors are fitted to cover washing, spin drying and drainage. This arrangement enables spin drying of a previous wash load and washing of a new wash load to be simultaneously effected. · To do this set the controls for both "wash" and "spin" modes(see "To Wash" and Spin Drying"). Laundry Guide Type of Febric Size of Water Wash Level Load (Volume) High (App. 33L) Degree Water of Temperature Wash Soiling Wash Cycle Period Heavy Hot 50°C Normal Max. Light Normal Light Warm 40°C 5-10 mins. Spin Period Fast Full Coloured Cotton and Half & Lines Less Nylon Full Half & Less Delicates Half & Less 4-5 mins. 2 mins. Normal Warm 40°C to Light 2-3 mins. 2 mins. Control Panel 0 15 3 WASH-RINSE 0 WOOL R 5 DRAIN AY O 1 N 12 WASH TIMER WATER INLET 9 6 VALVE SELECTOR(PUMP CONTROL) 4 3 2 SPIN TIMER 5 `6 OPERATING INSTRUCTIONS Emptying · Set the valve selector knob to "DRAIN". · Set the valve selector knob to "WASH. RINSE". · Switch off the electricity at the power point. CLEANING AFTER USE · Cleaning after use will extend your washing machine. Before cleaning shut off the power switch and disconnect the power cord from the electrical outlet, being sure to take hold of the plug. Filter · Remove the filter by pulling it forward(Fig. · Re-install the filter: By first inserting its bottom section and then pushing the upper part firmly into place. 2 1 Figure 2. Drain Strainer · Remove the drain strainer from the bottom of the tub using a sharp tool such as §^driver. · Wash off the lint stuck in the strainer. · Re-install the strainer. Pulsator · Dirt may also collect underneath the pulsator. · Clean out occasionally by remove the screw located in the center of the pulsator. · Hook the pulsator and pull upwards. · Wash off the lint stuck in the bottom of the wash tub. (When replacing the pulsator, make sure that screw is firmly tightened) 6 Figure 3. `7 POINTS TO REMEMBER · Avoid using excessive amounts of bleach, soap powder or detergent. Use the amount recommended by the respective manufacturers. [. . . ] · An article is lodged between the spin basket and tub. MAINTENANCE AFTER USE Wash Day Maintenance At the end of each wash day: · Switch off the electricity at the power point. · Check that both timers are set to the OFF position("0") · Wipe off spillage from wash powder, etc. , and generally wipe over the tub and base under with a clean damp cloth. · Remove the hose from water tap. * Design and specifications subject to change without notice. 7 `8 HOW TO FIX LEG TO BASE-HOLE FOR INSTALLATION · When you install this unit, be sure to assemble LEGS(4EA) to base under (Fig. [. . . ]