User manual DAEWOO DW-3600

[. . . ] the rear of the base and secure with the clamp provided. · The drain hose should be laid flat on the ground. Water flow will be restricted if any portion of the drain hose is raised 20 cm (8 in) from the ground. · The opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor. OPERATING INSTRUCTIONS Preparing the Wash · Sort the clothes into groups-whites, colorfast, non-colorfast, delicates, lint free, lint producers, etc. , and wash according to the laundry guide. [. . . ] This will activate the pulsator and washing will begin. Do not attempt to turn the dial from "OFF" to the left, nor past the "15" mark. 4 Washing Capacity Fabric (Inner clothing) Silk, Wool, Rayon, Nylon Natural/Synthetic fiber blends (Outer garments) Cotton, Linen (light fabric) Underwear Pajamas, Shirts Heavily solied work clothes, Cotton, Linens (heavy fabric) Silk, Wool, Nylon, Natural/ Synthetic fiber blends (heavy fabric) Water Washing Selector level & Detergent Time Switch Volume About 2-4min About 5-7 min About 8-10 min About 2-4 min About 6-8 min About 10 min Soft Below 1. 5 kg Normal Normal Low 31 L 40-50 g Normal Above 1. 5 kg Cotton, Linens Heavily Solied Work Clothes Cotton, Linens Normal High 43 L 55-65 g Normal Reference Item Sheet Under wear Shirts Sweater White shirt White shirt Work clothes Fabric Cotton Crape Synthetic fiber Wool Broad Nylon Cotton Unit weight About 400g About 130g About 200g About 300g About 200g About 160g About 600g 5 2. Drain By setting the selector DRAIN, the water will drain out of the washer. To spin dry and drain at the same time, first begin the spin drying process and after one minute or so start to drain out the water. WASH RINSE DRAIN DRAIN VALVE SELECTOR 3. Spin Dry 1 1 Spread out the clothes and place them one at time into the spin basket. 2 Close the spin dryer inner cover and outer cover. Remember that the machine will not spin if the cover is opened. open outer lid open inner lid 3 By turning the spin dryer timer to the desired time, rotation will begin. 0 5 1 4 3 SPIN TIMER 2 4 If there is any abnormal vibrating during spin drying, turn off the spin basket and rearrange the clothes uniformly inside the dry. stops NOTE: It is advisable to wiring out by hand any remaining suds in the clothing before placing them in the spin basket. If the spin dry outer lid is opened during spin drying rotation will automatically stop. 6 CAUTION Make sure that the spin basket has stopped rotating before opening the inner cover. Never reach into spin basket while it is still in motion. Be especially careful when children are present. 4. Rinse § Return the clothing to the washer tub and set the selector to WASH AND RINSE. § Open the faucet and supply water to the washer tub. Too mush water supplying during rinsing results in overflow and waste. Not enough water requires an excessive amount of time for through rinsing. Supply the proper amount of rinse water. § Adjust the washer timer in accordance with 0 the clothes to be rinsed. 15 3 Once the water becomes clean during the rinsing process, shut off the faucet and turn the washer time back to "0". Spin Dry 2 § After rinsing, spin dry the clothes again. § Supply water to the dryer to make sure that is completely free of any remaining detergent before putting in the clothes. Then follow the same process as in SPIN DRY. After the dryer comes to a complete stop remove the clothing. Clothing Clothing that wrinkless easily Light fabrics such as synthetics fibers, delicate material. Clothing that does not wrinkless easily Workclothes, Sheets, Underwear, thick fabric Spin dryer time About 1 minute 3-5 minutes NOTE: It is better to put small articles of clothing first such as socks and underwear into the spin basket, then put bulky and heavy clothing on top. 7 USEFUL INFORMATION FOR YOU WASHING MACHINE To ensure longer service from your washer, be sure to observe the following instructions. § Never operate the washer until the water has risen to a pre-set level. [. . . ] Check whether the belt is attached properly. If there is excessive noise: § Check whether something is touching the pulsator as rotates. Check whether the machine is placed level on the floor. Check whether there is an excessively unbalanced load in the spin basket while spinning. 9 HOW TO FIX LEG TO BASE-HOLE FOR INSTALLATION · When you install this unit, be sure to assemble LEGS(4EA) to base under(Fig. 4). [. . . ]