User manual DAEWOO DW-424

[. . . ] Empty out all pockets and close all slide fasteners. Treat bad stains prior to washing. Prior to Washing q q Remove the plastic spin mat from the spin bowl. Check that the wash timer knob is set to position "0" and that the drain selector is set to "wash · rinse". Also check that the lint filter is correctly positioned. Ensure the drain hose is in its correct position (see lnstallation). [. . . ] · Transfer either the full wash load or portion to the spin bowl commencing with small articles. Ensure that the clothes are evenly distributed. · Place the removable spin mat over the load to be dried and push lightly downward. (To contain delicated articles within the spin bowl. ) · Close the inner safety lid, then the outer lid. · Set the spin timer to the time recommended in the Laundry Guide. The spin bowl will spin for the time selected, then stop (at position "0"). Caution: Ensure that the spin bowl completely stops before reaching in to remove the wash load. · To remove or reposition clothes during the spin dry cycle, open the outer and inner lids. In this case, the spin bowl will automatically stop as a brake is applied when the outer lid is opened. Note: The pump motor will operate when the spin dry timer is set, irrespective of whether the outer lid is closed or opened. OPERATING INSTRUCTIONS Simultaneous Washing and Spin Drying · Three motors ate fitted to cover washing, spin drying and drainage. This arrangement enables spin drying of a previous wash load and washing of a new wash load to be simultaneously effected. · To do this, set the controls for both "wash" and "spin" modes (see "to wash" and "spin drying"). Laundry Guide Size of Wash Load Full Half & Less Full Half & Less Half & Less Degree of Soiling Heavy Normal Light Normal Light Wash Selection Switch Heavy Normal Hot 60°C Max. Water Temperature Wash Cycle Type of Fabric Fast Coloured Cotton and Linens Nylon and P. P Water Level High Medium Wash Period Spin Period High Medium or Low High Normal Soft Warm 40°C 4-5 mins. 2-3 mins. 2 mins. Delicates Normal to Light Soft Warm 40°C 2-3 mins. 1-2 min. . 3 Control Panel Drain Selector (Pump control) Water Inlet Wash Timer Wash Selector Spin Timer OPERATING INSTRUCTIONS Emptying · Set the valve selector knob to "drain" and the wash timer to 3-5 minutes. · Set the drain selector knob to "wash-rinse". · Switch off the electricity at the power point. Lint Filter · Remove the filter frame by pulling it upward (Fig. · Turn the filter inside out and wash the lint off with water (Fig. · Insert the filter frame into the puls-ator hole as it was (Fig. 2-(3)). ( 1) LINT (2) (3) Figure 2. Over flow Strainer · Remove the strainer by pulling it forward (Fig. · Wash off the lint stuck in the stra-iner during overflowing. · Re-install the strainer. Drain Strainer · Remove the drain strainer from the bottom of the tub using a sharp tool such as §^driver (Fig. · Wash off the lint stuck in the strainer. Figure 3. Pulsator · Should it be necessary to remove the pulsator, say to free an obstruction, first remove the filter frame by pulling it upward, and remove the screw securing the pulsator to the motor shaft Figure 4. · Remove the pulsator by pulling it upward. [. . . ] · The machine is placed on a level surface. · The wash load in the spin bowl is excessively unbalanced during the spin cycle. · An article is lodged between the spin bowl and tub. MAINTENANCE AFTER USE Wash Day Maintenance At the end of each wash day: · Switch off the electricity at the power point. · Check that both timers are set to the OFF position ("0"). [. . . ]