User manual DAEWOO DW-444PA

[. . . ] In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. Warning: Improper use of the grounding plug can result Use a 3-pronged in a risk of electric shock. [. . . ] Open the water tap and fill the tub to a suitable water level for the laundry. Set the drain selector to the drain position to discharge the water. Repeat proceses 1 to 4 twice or three time according to the condition of the washed laundry. Spin Drying To open the inner safety lid of the spin bowl, lift up the outer lid, then pull the catch forward and lift upward. Transfer either the full wash load or portion to the spin bowl commencing with small articles. Ensure that the clothes are evenly distributed. Place the removable spin mat over the load to be dried and push lightly downward. (To contain delicated articles within the spin bowl. ) Close the inner safety lid, then the outer lid. Set the spin timer to the time recommended in the Washing Guide. The spin bowl will spin for the time selected, then stop (at position "0"). Caution: Ensure that the spin bowl completely stops before opening the inner lid. If there is any abnormal vibration during spining, open the lids to stop the spin-tub and rearrange the clothes to be in good balance. If the drainage from the wash-tub and spin-tub occurs simultaneously, the drainage from spin-tub will be obstructed and there may be a malfunction. Therefore, if you need to drain the wash-tub while spinning, be sure to drain the wash-tub after at least one minute's spinning. Note: The pump motor will operate when the spin dry timer is set, irrespective of whether the outer lid is closed or opened. OPERATING INSTRUCTIONS Simultaneous Washing and Spin Drying Three motors ate fitted to cover washing, spin drying and drainage. This arrangement enables spin drying of a previous wash load and washing of a new wash load to be simultaneously effected. To do this, set the controls for both "wash" and "spin" modes (see "to wash" and "spin drying"). Washing Guide Size of Wash Load Full Half & Less Full Half & Less Half & Less Degree of Soiling Heavy Normal Light Normal Light Wash Selection Switch Heavy Normal 5-10 mins. Water Temperature Wash Cycle Type of Fabric Fast Coloured Cotton and Linens Nylon and P. P Water Level High Medium Wash Period Spin Period High Medium or Low High Normal Soft 4-5 mins. 2-3 mins. 2 mins. Delicates Normal to Light Soft 2-3 mins. 1-2 min. . 3 DW-444PA 00. 4. 26 11:8 AM `4 Control Panel Drain Selector (Pump control) Water Inlet Wash Timer Wash Selector Spin Timer OPERATING INSTRUCTIONS Emptying Set the valve selector knob to "drain" and the wash timer to 3-5 minutes. Set the drain selector knob to "wash-rinse". Switch off the electricity at the power point. Lint Filter Remove the filter frame by pulling it upward (Fig. Turn the filter inside out and wash the lint off with water (Fig. Insert the filter frame into the agitator hole as it was (Fig. 2-(3)). ( 1) LINT (3) Figure 2. Over flow Strainer Remove the strainer by pulling it forward (Fig. Wash off the lint stuck in the stra-iner during overflowing. [. . . ] The drain selector switch is set to "wash-rinse". If the spin dryer will not operate, check whether: The inner and outer spin bowl-lids are closed. The spin dry timer is set. If there is excessive noise, check whether: Something is touching the agitator as it rotates. The machine is placed on a level surface. The wash load in the spin bowl is excessively unbalanced during the spin cycle. [. . . ]