User manual DAEWOO DWC-051C

[. . . ] PRECAUTIONS FOR PROPER USE OF AIR CONDITIONER Please observe the following instructions. Operate the Selector Switch to run or stop the unit. - Do not use Main Power Switch or Auxiliary Power Switch to operate unit. Do not stick anything into the air outlet or inlet. [. . . ] The outside edge of window bracket should be 9. 4 inch (240mm) from center line. Adjust Screw (Type A) so that Sill Bracket have a slight tilt by using carpenter's level meter. Screw Type B SASH SILL BRACKET SI LL 480mm 600mm 240mm 300mm Screw Type A 720~915mm 610~914mm · Step 3 - Preparation of Chassis 1. Pull the Air-filter out of the Front Grille. Loosen screw which fasten Front Grille with driver. (when the knobs are too tight to release, leave them. ) 5 4. ­ Front Grille and chassis are fixed with snap-fit. ­ Push the right lower side of chassis to the left, with pushing left side of Front Grille to the right until the snap-fit is released. Push Push 2) Release left-lower snap-fit. ­ Push the left-lower side of chassis to the right, with pushing right side of Front Grille to the right until the snap-fit is released. Push Push 3) Pull lower side of the Front Grille until it is separated from the chassis. (when knobe remain, pull Front Grille until knobs are released from control) 4) Push base side of the Front Grille to upper side until it is separated from the chassis. 5. After front grille is removed, remove two screws located in both side of chassis and pull out the unit from chassis. 6 · Step 4 - Placing Chassis 1. Insert narrow side of `Frame Guide Lower' to rectangle holes Guide Lower located in bottom of chassis, and fasten it with Screw (Type D). Insert Window Kit Frames to Top Guide and Lower Guide. Fasten Shutter to side holes of Chassis with six Screws (Type D). Place the chassis on the window sill and align it with Sill Bracket and sill with Lower Frame Guide and locate window sash to Top Frame Guide. (check the end of chassis for about 1/2 inches (12mm) distance below the level. ) 5. Attach the Window seal B to Frame Guide Top. Fasten Front Chassis Bracket to sill with three Screws (Type C). Fasten Sash Bracket with Screw (Type C) to top of indoor window sash or directly into side of window sash or directly into side of window frame. This will prevent raising of the window from the outside. If you have a hard Screw (Type D) wood or metal window frame, a 1/8 inch pilot hole may be needed in order to drive the screws. Attach the Window Seal A to window (see the picture shown in step 8, page 8) FRAME Screw Screw (Type D, both side) E, side) Frame Guide Top Window Seal B SASH BRACKET Screw (Type C) Screw (Type C) · Step 5 - Secure Window Shutter CAUTION Do not drill into window sash until window has been inspected to make sure drilling or screw will not damage any locking or lifting mechanism located in the frame. To provide a proper seal, pull each expandable side Window Shutter out and up until it is tight against the window frame. [. . . ] · Confirm power cord is plugged in. · Verify main power switch (main circuit breaker) or fuse of the unit is good. · Wait 3 to 4 minutes and restart the unit. · When blocked by curtains, blinds, or furnitures, etc. , the air flow is restricted and cooling performance is affected. [. . . ]