User manual DAEWOO DWM-500M

[. . . ] Also, clothing may be deformed or decolored. laundry before spinning. This prevents laundry from being tossed out and damaged. s Before washing, check all pockets. If nails or pins remain in pockets, they may damage the washer or clothes. s To avoid water splashes, close the wash tub lid. s Never splash water on the control panel. s Close the water tap a little if the water pressure is too high. ELECTRIC CONNECTION (ONLY FOR DUAL VOLTAGE MODEL) s If you want to change the voltage, remove the back cover and reset the connector as figures. s Make sure that electric connector is set for your available voltage before operating the washing machine. s This unit is set for 220V. (240V) 1 , , , , DESCRIPTION OF PARTS SPIN DRYER LID When you open this lid while the spin basket is spinning, the spinning will be stopped by brake system. WATER DRAIN HOSE (PUMP MODEL) INNER LID SAFETY COVER SPIN DRYER BASKET. OVERFLOW FILTER POWER CORD WASH TUB LID During operation, close the wash tub lid. The plug's shape may not correspond with this drawing. DRAIN FILTER WASH TUB PULSATOR BASE LEG EARTH WIRE (OPTION) WATER DRAIN HOSE (NON-PUMP MODEL) CONTROL PANEL ! [. . . ] (see page 5) $ Put laundry in the wash tub. ^ After washing, set the WASH SELECTOR to "DRAIN" for drain and set the TIMER to the proper time. ¡Æ SPIN DRY TO !Transfer the clothes into the spin basket and arrange it evenly. @ Be sure to put the safety cover and close the inner lid. $ Set the SPIN SELECTOR to "SPIN". % Set the TIMER 1~5 minutes. ¡Æ RINSE TO !Set the WASH SELECTOR to "WASH · RINSE". @ Supply the proper amount of water as not to overflow the top of the washing tub. $ To drain the water, set the WASH SELECTOR to "DRAIN" and set the TIMER to the proper time. % Repeat this cycle until drain water is clean. (2~3 cycles) ¡Æ OVER FLOW RINSE !Set the WASH SELECTOR to "WASH · RINSE". (Adjust water pressure to ensure that the amount of supplied does not exceed the amount of drain. ) # Set the TIMER 6~8 minutes. $ As soon as the TIMER shuts off or the rinsing water become clear, turn off the water tap. % To drain the water, set the WASH SELECTOR to "DRAIN" and set the TIMER to the proper time. 3 , , , , INSTALLATION s LOCATION & ENVIRONMENT Leave some space. Space at least 10cm between the washer and the wall. [. . . ] # Install the drain hose under 85cm from the ground. (In case DRAIN PUMP model) (NO DRAIN PUMP) Less than 10cm (PUMP) 85Cm s LEG SETTING Slide the leg into the opening underneath the base, and push. CLEANING & MAINTENANCE Proper care of your washer can extend its life. s CLEANING THE OVERFLOW FILTER Insert your finger into hole "A" and then pull the overflow filter in the direction of arrow as shown in the figure. A s CLEANING THE DRAIN FILTER In case of incomplete drain, remove lints from the drain filter with soft brush. s CLEANING THE WASHER BODY Wipe of stains on the cabinet and control panel with soft cloth. Do not use benzene, thinner, cleanser or wax. [. . . ]