User manual DAEWOO FR-135DFW

[. . . ] s Top Table Useful for putting non-frozen foods or home-appliances to use space efficiently. Turn the multi-use tray up side down when putting microwave oven on top. Foots of the microwave oven should not stay out of the tray. Also do not use microwave ovens that are larger than the size of top table. ! [. . . ] The discoloring can occur to the refrigerator. 2. RADIANT HEAT? With the Refrigerating System in operation, it is likely that the cabinet will feel warm at the front edges and sides. It is due to the hot-line used in this type of Refrigerating System which consists of piping hot gas from the (motor-driven) compressor along the front edges, the sides of the cabinet and the center partition to prevent dewing. This has nothing to do with the storage temperature inside. (The thick line indicates the hot-line) NOTE: During spells of hot, humid weather and in rainy season, moisture may develop on the cabinet, just as water condenses around a cold glass of water. It is not an abnormal condition; wipe off the moisture with a dry cloth. This can also happen when the refrigerator is not installed in an appropriate place. · For good ventilation place refrigerator with the spaced specified on the figure. This helps cooling efficiency and lowers the electricity bill. · Placing the refrigerator on the carpet may cause heat to develop and discolor the appliance. In such a case put a hard wooden board or a rubber mat between the refrigerator and the carpet. m 30c ast At le Carpet At le ast 15c m cm 15 st lea At Wooden Board, Rubber Mat 3 4 2. INSTALLATION STEPS · Select a safe place to install your refrigerator. · Level the refrigerator by using the adjustable foot. · Install the parts to their own place. 3. THINGS TO KNOW BEFORE MOVING OR RELOCATING THE REFRIGERATOR! · Unplug the power cord. · Take food out of the refrigerator compartments. · Fasten the interior components with tape. n llatio instae Safe plac Maintain ~ Level Com p origonents inal to plac their es Adhesive Tape · Check if the doors are completely shut. · Check the voltage and wait about an hour before plugging the power cord into an outlet. · After running the refrigerator for 2 ~ 3 Hours put food in the refrigerator. · For relocating indoors use the wheels. · When moving have two people carry the refrigerator for safety · Fasten the doors with tape while moving to prevent them from opening. Plug in after about hour after food s Put ~3 hour 2 Relocating Indoors Ad hes ive Check Check Ta pe 5 6 WHAT TO DO. . . 4. CLEANING YOUR REFRIGERATOR · When cleaning your refrigerator, unplug the power cord and use a soft cloth and dishwashing liquid to clean. · The refrigerator can smell on its initial operation, but the odor will be away when the refrigerator is cooled sufficiently. · Use a soft cloth for cleaning the interior and exterior of the refrigerator. When not operating for a long time s Remove the power supply cord. s Dry your refrigerator by opening the door for 2-3 days. When you get ready to move s Securely fasten movable interior parts (or remove and pack them separately). s DO NOT lay down your refrigerator horizontally, or the compressor may be damaged. Before you call for service, please check the following points first. If the refrigerator is not operating: s Is the power supply cord unplugged?s Is the home fuse or circuit out of order? [. . . ] Written authorization must be obtained before any merchandise is returned to the factory. This warranty does not extend to any of our electronic products which have been subjected to misuse, neglect, accident, incorrect wiring not our own, improper installation, unauthorized modification, or to use in violation of instructions furnished by us, nor units which have been repaired or altered outside of our factory, nor to cases where the serial number there of has removed, defaced, or changed. This warranty is in lieu of all warranties expressed or implied and no representative or person is authorized to assume for us any other liability in connection with the sales of our electoronic products. Initial defective is described as when the dealer opens the unit and finds that it is inoperative or an individual customer opening a new unit and finding that it is initially defective. [. . . ]