User manual DAEWOO IMPALA POLICE 2011

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual DAEWOO IMPALA POLICE. We hope that this DAEWOO IMPALA POLICE user guide will be useful to you.

Lastmanuals help download the user guide DAEWOO IMPALA POLICE.


Mode d'emploi DAEWOO IMPALA POLICE
Download
Manual abstract: user guide DAEWOO IMPALA POLICE2011

Detailed instructions for use are in the User's Guide.

[. . . ] 2011 Chevrolet Impala Police Package M Keys, Doors and Windows . 4-1 Warning Lights, Gauges, and Indicators . i-1 ii Introduction The information in this manual supplements the owner manual. This manual describes features that may or may not be on your specific vehicle either because they are options that you did not purchase or due to changes subsequent to the printing of this owner manual. [. . . ] Transmission Fluid Cooler Your Impala police vehicle is equipped with auxiliary fin-type air-to-oil coolers mounted in front of the engine coolant radiator. Notice: Overloading the vehicle's electrical system may damage your vehicle's accessories. Special Equipment Options The engine oil and power steering fluid coolers are mounted on a common frame to the right of center. The transmission fluid cooler is mounted separately to the left of center and provides fluid cooling in addition to the coolant radiator end-tank cooling. 15-3 Trunk Ground Stud A 10 mm flanged hex nut grounds the 10 mm bolt to the vehicle. Recommended torque for the flanged nut is 35 N·m (26 lb ft), plus or minus 5 N·m (4 lb ft). A 10 mm hex nut is provided for customer ground termination. Recommended torque for the terminal connection nut is 10 N·m (7. 3 lb ft), plus or minus 1. 3 N·m (1 lb ft). A 10 mm ground stud can be found in the trunk on the passenger side of the vehicle. The stud is located above the trunk auxiliary junction block. See "Trunk Auxiliary Battery Power Junction Block" that follows for more information on location. 15-4 Special Equipment Options Wiring Provisions for 12-Volt Battery Power Supply Special Equipment Options 15-5 15-6 Special Equipment Options Two 30 amp circuit breakers supply power from the 65 amp fusible link through the contacts of the control relays to 3. 0 mm² (12 gauge) blunt cut wires. The blunt cut leads are part of a 1. 5 m (5 ft) loop of wire coiled under the instrument panel in the front passenger side footwell. Each relay is operated by an 0. 8 mm² (18 gauge) blunt cut, light or dark blue control lead included in the 1. 5 m (5 ft) coil under the instrument panel. An 8. 0 mm² (8 gauge) ground lead is also provided in the 1. 5 m (5 ft) coil. The total current available through the 12-volt power supply is 110 amps (1320 watts). Blunt cut ignition controlled power and signal circuits are also included in the following 1. 5 m (5 ft) right foot loop: . Battery power is supplied through two fusible links, one 50 amp and one 65 amp, to three circuit breakers and two control relays located in the relay center above the accelerator pedal. For location information, see "Servicing Relays and Circuit Breakers" in the Index. A 50 amp circuit breaker feeds power directly from the 50 amp fusible link through a 5. 0 mm² (10 gauge) blunt cut wire. A yellow, 0. 5 mm² (20 gauge) 10 amp fused circuit, Hot in ACC/ACCESSORY, ON/RUN or RAP (Retained Accessory Power). The fuse for this circuit is labeled "RAP" and is located in the fuse block in the front passenger side instrument panel. A pink, 0. 5 mm² (20 gauge) 10 amp fused circuit, Hot in START and ON/RUN. The fuse for this circuit is labeled "PWR DROP/CRANK" and is located in the underhood fuse block in the engine compartment. . Special Equipment Options . 15-7 A yellow/black, 0. 5 mm² (20 gauge) transaxle park signal from the Body Control Module (BCM). The circuit provides a switched power when the transaxle is not in PARK (P) and the engine is running. The electrical load attached to the park circuit must not exceed 0. 5 amps and is meant to drive one relay coil. A brown, 0. 35 mm² (22 gauge) vehicle speed signal (4, 000 pulses/mile) from the ABS module. Connect only high impedance load. Servicing Relays and Circuit Breakers The following information shows you where the relays and circuit breakers are located in the Fuse BlockSEO. . Enlarged View of the SEO Fuse Block A. Relay Center for Circuit Breakers and Control Relay C. [. . . ] 15-2 Power Steering/Engine Oil Cooling System . 15-2 K Keys Single Key Random Code System . 1-1 Q Questions and Answers About Airbags and Specialty Law Enforcement Vehicles . 15-15 Rear Windows Inoperative - SEO 6N5 . [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE DAEWOO IMPALA POLICE

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual DAEWOO IMPALA POLICE will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag