User manual DAEWOO MEC-360

[. . . ] Unstable installation can produce noise and vibration. ¥ Place your refrigerator where there is no heat source nearby. High atmosphere temperature will lower cooling efficiency and increase your electricity bill. ¥ Place the refrigerator in an area where the humidity level is low. [. . . ] ¥ Level the refrigerator by using the adjustable feet. ¥ Install the parts in their own place. 3. WHAT YOU NEED TO KNOW BEFORE MOVING OR RELOCATING THE REFRIGERATOR! ¥ Unplung the power cord. ¥ Detach the grille and the defrost-drain vessel from the refrigerator with driver and then remove water from the defrostdrain vessel located at the rear of the refrigerator. ¥ Take food out of the refrigerator. n llatio instae Safe plac Maintain ~ Level Com p origonents inal to plac their es ¥ Check if the doors are completely closed. ¥ Check the voltage. Then wait about an hour before plugging the power cord into the outlet. ¥ Put food in the refrigerator after running the refrigerator for 2~3 hours. ¥ Fasten the interior components with adhesive tape. ¥ Have two people carry the refrigerator to move safely. ¥ Fasten the doors with adhesive tape to prevent from opening while moving. Plug in after about hour after food s Put ~3 hour 2 Adhesive Tape Check Check Ad hes ive Ta pe 5 6 HOW TO INSTALL 4. CLEANING YOUR REFRIGERATOR ¥ Before you clean the refrigerator, unplug the power cord. Wash with warm, soapy water rinse and dry. ¥ The refrigerator may smell during the initial operation, but the odour will fade away when the refrigerator is cooled sufficiently. ¥ Use a soft cloth for cleaning the interior and exterior of the refrigerator. Location Install the refrigerator in a convenient location away from extreme heat and cold. Allow at least 6cm clearance between the refrigerator and side wall so that the door may open for a fully usable interior and the refrigerator may have good air circulation. The refrigerator is not designed for recessed installation. the wall s Select a strong and level floor. s Keep 6cm of space between the refrigerator and the walls. Soft cloth Soft cloth 6cm Leveling ¥ Do not sprinkle water directly on the refrigerator itself. ¥ Put the parts back in their original positions after cleaning. Level the refrigerator so that it rests solidly on the floor without rocking. There are two leveling feet at each front corner. Turn to the left to raise a corner, to the right to lower it. Use shims under the rear corners, if necessary. s If you want the refrigerator door to close naturally, adjust the leveling feet so that the front of the refrigerator is raised by 5mm. s If you want the refrigerator to remain motionless when open, adjust the leveling Com p origonents inal to plac their es feet so that all four corners are leveled with each other. Water All packing materials used to ensure safety during transport should be removed. You must remove the transport safty packing and wipe off any possible adhesive tape residues with a petroleum-based cleaner or similar solvent. 7 8 HOW TO OPERATE 1. TEMPERATURE CONTROL Temperature is controlled by thermostat automatically. The Temperature Control inside the refrigerator controls the degree of cooling for each compartment. DEFROSTING THE REFRIGERATOR You will never have to defrost your refrigerator as it is designed to defrost itself completely and automatically. Refrigerator Temperature Control WINTER MAX CAUTION MIN MED TEMP. [. . . ] When you get ready to move s Securely fasten movable interior parts (or remove and pack them separately) s DO NOT lay down your refrigerator horizontally, or the compressor may be damaged. Before you call for service, please check the following points first. If the refrigerator is not operating: s Is the power supply cord unplugged?s Is the home fuse or circuit out of order?If the refrigerator is warmer than usual: s Has the door been opened frequently or for a long period?s Are there any hot food or anything that has been stored without cooling? [. . . ]