User manual DAEWOO RCC-740

[. . . ] For proper operation, please read this manual before using. RCC-740 EN 6/19/06 3:26 PM Page 3 IMPORTANT SAFETY INSTRUCTIONS WARNING To reduce the risk of fire, electrical shock, injury to persons or damage when using your vacuum cleaner, follow basic safety precautions including the following; 1. Use only manufacturer's recommended attachments. Do not leave appliance when plugged in, Unplug from outlet when not in use and before servicing. Do not allow to be used as a toy. Close attention is necessary when used by or near children. [. . . ] Turn off controls(switch) before unplugging. This appliance is intended for household use only and not for commercial or industrial use. It must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. 2 RCC-740 EN 6/19/06 3:26 PM Page 4 NAMES OF PARTS AND USING FLOOR NOZZLE Select the appropriate settting of the pedal according to the surface to be cleaned. Carpet Hard Floor TELESCOPIC TUBE Press the button in the direction shown by the arrows or pull(or push) out the tube. Handle grip Suction control TUBE / NOZZLE CONNECTOIN Rotate the tubes in the direction shown by the arrows and pull tubes(or floor nozzle) apart. Telescopic tube HOSE INSTALLATION / REMOVAL Hold the hose and match tabs to align with slot inlets of the vacuum cleaner. Push firmly until hose locks into place. To remove hose, press the button on the hose, then pull the hose out from the vacuum cleaner. Main floor nozzle CABLE REWIND BUTTON CABLE REWINDBUTTON CABLE BUTTON 3 RCC-740 EN 6/19/06 3:26 PM Page 5 SUCTION CONTROL If you slide the suction control on the hose, you can adjust suction power. POWER CONTROL SWITCH Adjust the suction power by rotating the swich on the unit. DUST FULL INDICATOR Carry handle, Cord rewind Dust box This red on which means the dust box is full or the filter in the dust box is blocked by the dust. Please empty the dust box and clean the filter in the dust box. RED CABLE REWIND BUTTON CABLE REWINDBUTTON CABLE BUTTON Pull out the power cable to the desired length. To rewind the power cable, push down on the carry handle. Hold the plug while the power cable is rewinding to prevent the power cable from whipping. ON/ OFF SWITCH BUTTON Turn the unit off(on) by pressing the ON/OFF switch button on the unit. 4 RCC-740 EN 6/19/06 3:26 PM Page 6 USING THE DUSTING BRUSH / CREVICE NOZZLE Fit the dusting brush or crevice nozzle onto the end of the handle grip or the telescopic tube. The dusting brush is for vacuuming the window frame or irregular surfaces. The crevice nozzle is for vacuuming in those hard-to-reach places. Crevice nozzle Dusting brush When use the crevice mozzle, the dust full indicator may be operated. NOTE STORAGE Collapse the telescopic tube completely. Slide the tube clip on the telescopic tube into the slot on the rear of the vacuum cleaner. Slide the tube clip on the telescopic tube into the slot on the bottom of the vacuum cleaner. Tube clip Button Tube clip Slot Slot 5 RCC-740 EN 6/19/06 3:26 PM Page 7 USING THE CARRY HANDLE Move the vacuum cleaner to the other place by holding the carry slot under the one. Pull the carry handle out from the vacuum cleaner, then move the vacuum cleaner to the other place by holding the one. Carry handle Carry slot Vacuum cleaner NOTE Handle of dust box Dust box If you lift the handle of the dust box up, the dust box is separated. Do not use the handle of the dust box for carrying. Use the handle of the dust box for only emptying the dust box. CLEANING THE FLOOR NOZZLE Hair, loose clothing, lint, etc. Fit the dusting brush or crevice nozzle onto the end of the handle grip, then remove the hair, loose clothing or lint on the opening of the floor nozzle. 6 RCC-740 EN 6/19/06 3:26 PM Page 8 EMPTYING THE DUST BOX The dust box needs emptying when dust reaches the MAX mark on the dust box or the dust full indicator is on. 1 Dust box EMPTYING THE DUST BOX Lift the dust box up. 2 Hold the dust box over wastebasket and press the release button, then dust will fell down as the cover is open. Cover vacuum cleaner Release button If the dust full indicator is on after emptying the dust box, dust box or filter needs cleaning. SEPARATING THE DUST BOX 1 Pull out of the cover release button in the direction shown by the arrows. Cover Release button The dust box when separating, put certainly in table place or the dust box catch. If not, the NOTE dust box there is a possibility of falling. 2 Remove the filters by rotating clockwise. 3 Pull out the filter from the frame. CLEANING THE FILTERS 1 2 3 4 Pull out the washing brush from the unit and clean the washable filter with the washing brush. Allow the washable or mesh filter to dry completely in a shaded location for dry. If not dry out the washable filter, do not use the vacuum cleaner. The wet washable filter make the vacuum cleaner trouble. NOTE 7 RCC-740 EN 6/19/06 3:26 PM Page 9 EMPTYING THE DUST BOX EMPTYING THE DUST BOX Guide Cover 1 Filter assembly 2 Filter assembly Tab Projection Dust box Attach filter assembly to the guide by rotating counter clockwise unit it locks into place. [. . . ] Please, dispose of this equipment at your applicable collection point for the recycling of electrical & electronic equipments waste. In the European Union and Other European countries which there are separate collection systems for used electrical and electronic product. By ensuring the correct disposal of this product, you will help prevent potentially hazardous to the environment and to human health, which could otherwise be caused by unsuitable waste handling of this product. The recycling of materials will help conserve natural resources. [. . . ]