User manual DAEWOO TAHOE HYBRID 2011

[. . . ] 2011 Chevrolet Tahoe and GMC Yukon/Yukon Denali Hybrid M In Brief . 5-2 Warning Lights, Gauges, and Indicators . 11-1 Recommended Fluids, Lubricants, and Parts . i-1 ii Introduction Please refer to the purchase documentation relating to your specific vehicle to confirm each of the features found on your vehicle. [. . . ] With your foot on the brake pedal, move the shift lever through each gear range, pausing for about three seconds in each range. Then, move the shift lever back to P (Park). Allow the engine to idle (500­800 RPM) for at least one minute. Keep the engine running and press the Trip/Fuel button or trip odometer reset stem until TRANS TEMP (Transmission Temperature) displays on the Driver Information Center (DIC). Using the TRANS TEMP reading, determine and perform the appropriate check procedure. If the TRANS TEMP reading is not within the required temperature ranges, allow the vehicle to cool, or operate the vehicle until the appropriate transmission fluid temperature is reached. Automatic Transmission Fluid When to Check and Change Automatic Transmission Fluid It is usually not necessary to check the transmission fluid level. The only reason for fluid loss is a transmission leak or overheating the transmission. If a small leak is suspected, then use the following checking procedures to check the fluid level. However, if there is a large leak, then it may be necessary to have the vehicle towed to a dealer service department and have it repaired before driving the vehicle further. Notice: Use of the incorrect automatic transmission fluid may damage the vehicle, and the damages may not be covered by the vehicle warranty. Always use the automatic transmission fluid listed in Recommended Fluids and Lubricants on page 111. How to Check Automatic Transmission Fluid Notice: Too much or too little fluid can damage the transmission. Too much can mean that some of the fluid could come out and fall on hot engine parts or exhaust system parts, starting a fire. Too little fluid could cause the transmission to overheat. Be sure to get an accurate reading if checking the transmission fluid. Before checking the fluid level, prepare the vehicle as follows: 1. Start the engine and park the vehicle on a level surface. Apply the parking brake and place the shift lever in P (Park). Vehicle Care Cold Check Procedure Use this procedure only as a reference to determine if the transmission has enough fluid to be operated safely until a hot check procedure can be made. The hot check procedure is the most accurate method to check the fluid level. Perform the hot check procedure at the first opportunity. Use this cold check procedure to check fluid level when the transmission temperature is between 24°C and 34°C (75°F and 93°F). 10-7 1. Locate the transmission dipstick at the rear of the engine compartment, on the passenger side of the vehicle. See Engine Compartment Overview on page 104 for more information. [. . . ] See Drive Motor/Generator Control Module (DMCM) Cooling System on page 109. Drive Motor/Generator Control Module (DMCM) Cooling System Technical Data 12-1 Technical Data Vehicle Data Capacities and Specifications . 12-3 12-2 Technical Data Vehicle Data Capacities and Specifications Application Automatic Transmission* (Pan Removal and Filter Replacement) Cooling System Drive Motor Generator Control Module Cooling System 6. 0L V8 Engine Cooling System Fuel Tank 2. 7 L 17. 3 L 92. 7 L 2. 9 qt 18. 3 qt 24. 5 gal Capacities Metric 10. 9 L English 11. 5 qt *Transmission fluid capacity is approximate. See Automatic Transmission Fluid on page 106 for information on checking fluid level. Recheck fluid level after filling. Technical Data Engine Specifications Engine 6. 0L V8 VIN Code J Transmission Automatic Spark Plug Gap 12-3 1. 02 mm (0. 040 in) Engine Drive Belt Routing 12-4 Technical Data 2 NOTES INDEX i-1 A Adjustments Lumbar, Front Seats . [. . . ]