User manual DAEWOO TAHOE POLICE 2010

[. . . ] 2010 Chevrolet Tahoe Police and Special Service Packages M Seats and Restraint System . 3-2 Starting and Operating Your Vehicle . 4-1 4-2 4-2 4-5 Service and Appearance Care . 6-1 6-2 6-2 6-3 Special Equipment Options . [. . . ] During nighttime conditions, the low-beam headlamps turn on automatically while the high-beam headlamps flash. Turning on the high-beam headlamps manually with the turn signal/multifunction lever will override the flashing module and the high-beam headlamps will operate continuously. 15-2 A 20 amp fuse protects the flasher module circuit. This fuse is located in the underhood fuse block in the engine compartment on the driver side of the vehicle and is labelled HEADLAMP WASH . See "Underhood Fuse Block" in the Service and Appearance Care section of the Tahoe owner's manual for more information. When it is dark outside, the taillamps will turn on automatically. The Center High-Mounted Stoplamp (CHMSL) will not flash and will operate only when the regular brake pedal is pressed. Headlamps Flasher Module -- SEO 6J7 15-3 Forward Lamp Harness In-Line Connector for use with Headlamps Flasher Module, Option 6J7 15-4 Inactive Rear Door Handles - SEO 6B2 Your vehicle may be equipped with inactive door handles. The rear doors can only be opened from the outside. Spotlamp - SEO 7X6 Spotlamp Windshield Pillar Mounted Inactive Rear Door Windows - SEO 6N5 Your vehicle may be equipped with inactive rear door window control switches. Only the driver's power window switches can operate the rear windows. Inactive Rear Door Locks - SEO 6N6 Your vehicle may be equipped with inactive rear door locks. The rear door locks do not lock or unlock at the door. Only the driver's power door lock switch locks or unlocks the rear door locks. A Unity Series 330, high intensity, 100 watt halogen (H3 bulb) six inch (15 cm) spotlamp is mounted in the left windshield pillar. The lamp is protected by a 15 amp fuse located in the underhood electrical center. See the service manual for lamp replacement procedures. 15-5 Wiring Provisions for Horn/Siren Circuit - SEO 6J4 Spotlamp Harness SEO 7X6, SEO 7X7 Spotlamps - SEO 7X7 SEO 7X7 includes a driver side and a passenger side spotlamp located in the windshield pillars. Each spotlamp is protected by a separate 15 amp fuse located in the underhood electrical center. For spotlamp bulb replacement procedures, see the appropriate section of the service manual. This provision permits customer connection of a switch to select either horn or siren operation when the horn pad is pressed. A 22 gauge (0. 35 mm²) wire is connected to an in-line connector in the horn circuit of the instrument panel harness under the instrument panel. The end of this harness extension is in a 5 foot (1. 5 m) loop of wire coiled under the center of the instrument panel. 15-6 Wiring Diagram for SEO 6J4 Inline Connector 15-7 Wiring Provisions for Vehicle Grille Lamps, Flasher and Speaker/Siren - SEO 6J3 B. Control Wires from In-Line Connector in Forward Lamp Harness for Customer-Furnished Grille Lamps and Speaker This wiring provision option consists of one 16 gauge (1. 0 mm²) wire connected to an alternating signal flasher located underneath the instrument panel on the passenger side. Five feet (1. 5 m) of extra wire from the flasher is routed from underneath the instrument panel to an area behind the grille. All four wires have 12 inches (30 cm) of extra wire in a coil behind the grille. Grille lamps and the speaker are not included. [. . . ] . 4-5 E Exterior Lamp Emergency Flashing System - SEO 6J7 . . 4-2 B Battery Dual System - SEO 6A6 . 4-5 Grounding Studs, Equipment, Rear Compartment . 15-19 Grounding Studs, Radio Suppression . [. . . ]