User manual DAHON INTER 8 HUB SG-8R20 TECHNICAL SERVICE INSTRUCTIONS

[. . . ] For maximum performance we highly recommend Shimano lubricants and maintenance products. For any questions regarding methods of handling or adjustment, please contact the place of purchase. Align the red marks to install. 7R Mark Align the red marks to install. The projecting parts should be on the fork end side. Install the non-turn washers so that the projecting parts is securely in the fork end grooves on either side of the hub axle. Right side of the hub body 3. [. . . ] Use lock nuts with nylon inserts (self-locking nuts) for the clip nut. It is recommended that standard Shimano parts be used for the clip screw, clip nut and brake arm clip. If the clip nut comes off the brake arm, or if the clip screw or brake arm clip becomes damaged, the brake arm may rotate on the chainstay and cause the handlebars to jerk suddenly, or the bicycle wheel may lock and the bicycle may fall over, causing serious injury. 1. Install the driver cap to the driver on the right side of the hub body. Driver cap Mount the chain on the sprocket, and then set the hub axle into the fork ends. Hub axle Fork end Note the direction Tightening torque: 30 ­ 45 Nm {260 ­ 390 in. lbs. } Cap nut Non-turn washer Non-turn washer Washer Cap nut Mudguard stay Carrier stay If excessive force is applied to the brake arm, the wheel will become difficult to turn. Make sure that you don't apply excessive force when installing. Clip screw (M6 16 mm) SE GREA General Safety Information WARNING ­ To avoid serious injuries: Obtain and read the service instructions carefully prior to installing the parts. Loose, worn, or damaged parts may cause serious injury to the rider. We strongly recommend only using genuine Shimano replacement parts. It is important to completely understand the operation of your bicycle's brake system. Improper use of your bicycle's brake system may result in a loss of control or an accident, which could lead to severe injury. Because each bicycle may handle differently, be sure to learn the proper braking technique (including brake lever pressure and bicycle control characteristics) and operation of your bicycle. This can be done by consulting your professional bicycle dealer and the bicycle's owners manual, and by practicing your riding and braking technique. These brake levers are equipped with a mode switching mechanism to make them compatible with cantilever brakes and Roller Brakes or V-Brakes with power modulator. SI-6J30A SB-8S20 BL-IM60 CJ-8S20 Disconnecting the shifting cable when removing the rear wheel from the frame Disconnect the cable from the cassette joint when removing the rear wheel from the frame. Installation of the shifting cable Use a shifting cable with one inner cable drum. the SIS-SP40 5. Pass the inner cable throughthe plastic cap. Turn the cable 60 to the hook. Hook counterclockwise and attach it Adjusting the cassette joint Revo-shift lever to 4 . [. . . ] Replace the upper cover and tighten the cover fixing screw. Cover fixing screw Pulley hole Upper cover Inner cable fixing nut Pulley OK Gap in pulley Not OK These service instructions explain how to use and maintain the Shimano bicycle parts which have been used on your new bicycle. For any questions regarding your bicycle or other matters which are not related to Shimano parts, please contact the place of purchase or the bicycle manufacturer. These service instructions are printed on recycled paper. [. . . ]