User manual DAHON SL-R770 TECHNICAL SERVICE INSTRUCTIONS

[. . . ] Remove the two indicator set screws which are securing the indicator. Tightening torque : 0. 3 - 0. 5 N·m {3 - 4 in. lbs. } Indicator set screws Indicator 1. Remove the two indicator set screws which are securing the indicator. Tightening torque : 0. 3 - 0. 5 N·m {3 - 4 in. [. . . ] To shift two steps at one time, Lever (A) initial position press to the position. A maximum three-step shift can be made in this manner. Example: from intermediate chainring to largest chainring. 4. After checking that the indicator needle is at the right edge, install the indicator as shown in the illustration. 4. After checking that the indicator needle is at the left edge, install the indicator as shown in the illustration. : Shifts one sprocket E. x. : from 3rd to 4t 43 To shift from a large chainring to a smaller chainring When lever (B) is pressed once, there is a shift of one step from a large chainring to a smaller chainring. Example: from largest chainring to intermediate chainring. 5. If it does not operate correctly, re-install the indicator by while taking particular note of steps 3. If it does not operate correctly, re-install the indicator by while taking particular note of steps 3. and 4. Replacement of the shifting lever unit Replacement of the shifting lever unit Disassembly and reassembly should only be carried out when replacing the shifting lever unit. Loosen the cable fixing bolt (nut) of the rear derailleur, and then pull the inner cable out of the shifting lever unit in the same way as when installing the inner cable. Carry out steps 1 - 2 for replacement of the indicator. Remove the three shifting lever mounting screws, and then remove the shifting lever unit as shown in the illustration. Tightening torque : 0. 5 - 0. 8 N·m {4 - 7 in. lbs. } : Quick-shifts two sprockets E. x. : from 3rd to 5th 5 3 Disassembly and reassembly should only be carried out when replacing the shifting lever unit. [. . . ] lbs. } Inner cable Inner hole cover Lever (B) Front derailleur Front chainwheel Rear derailleur Freehub Cassette sprocket Chain Bottom bracket cable guide Outer end cap Attach the same outer end cap to the cut end of the outer casing. This service instruction explains how to use and maintain the Shimano bicycle parts which have been used on your new bicycle. For any questions regarding your bicycle or other matters which are not related to Shimano parts, please contact the place of purchase or the bicycle manufacturer. One Holland, Irvine, California 92618, U. S. A. Phone: +1-949-951-5003 Industrieweg 24, 8071 CT Nunspeet, The Netherlands Phone: +31-341-272222 3-77 Oimatsu-cho, Sakai-ku, Sakai-shi, Osaka 590-8577, Japan Install the inner hole cover by turning it as shown in the illustration until it stops. [. . . ]