User manual DAHON SPEED DIAL 7

[. . . ] LEVER INSTALLATION IMPORTANT! Only brakes designated for direct-pull levers such as the Single Digit® Ultimate, Single Digit® Ti, 7, 5 and 3 brakes can be used with Avid levers. If you have any questions concerning compatibility of levers and brakes, contact your professional bike dealer. If you do not understand the instructions, have the installation done by a professional bike mechanic. 1 INSTALL THE LEVER Slide the lever onto the bar to the proper position. [. . . ] After installation, adjust the knob for the exact brake feel that you want. 4 SET ADJUSTER BARREL Before installing the cable, adjust the barrel adjuster about half way out. Make sure that the barrel slot lines up with the slot in the body. 5 INSTALL CABLE Feed the cable through the housing to the brake and install the cable end into the link. Slots SPD-02/02 6 ATTACH CABLE TO BRAKE Follow the installation instructions for your specific brake. Refer to these instructions for torque specifications and brake setup. 7 ADJUST BARREL Use the barrel adjuster to take up any slack in the cable. 8 TEST THE SYSTEM With two fingers, squeeze the brake lever firmly about a dozen times to ensure the cables are seated properly and operate smoothly. Make sure the cable has not slipped at the cable anchor bolt. Re-torque if necessary. LIMITED WARRANTY Avid, LLC (Avid) warrants to the original consumer purchaser of every Avid product that the product shall be free from defects in workmanship and materials for a period of one (1) year from the original date of purchase. The sole remedy under this warranty is limited to, at Avid's sole discretion, repair or replacement of the defective product. Labor and shipping costs are excluded from this warranty. This warranty only applies to the original consumer purchaser and is not transferable. THIS WARRANTY DOES NOT COVER normal wear and tear (including, without limitation, brake pad wear), or defects or failures that are related in any way to improper installation or follow-up maintenance, accident, abuse or neglect (including, without limitation, thread damage). Since Avid has no control over the product's final use, Avid also does not warrant the suitability of the product for specific riders and/or uses. IN NO EVENT SHALL AVID BE RESPONSIBLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, WHETHER BASED ON CONTRACT, WARRANTY, NEGLIGENCE, OR STRICT OR PRODUCTS LIABILITY, INCLUDING WITHOUT LIMITATION, PERSONAL INJURY DAMAGES, PROPERTY DAMAGE OR ECONOMIC LOSSES. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. ALL IMPLIED WARRANTIES, INCLUDING ANY WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSLY LIMITED TO THE ONE (1) YEAR DURATION OF THIS WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Claims under this warranty may be initiated with any Avid dealer. If this is not practical, you may contact Avid in writing at the address listed below. [. . . ] Use a 2mm hex wrench to check the pivot pin set screw. Other benefits of Speed Dial include matching the feel of the front and rear brakes, especially if the arm lengths or brake boss heights differ. This design allows the blade to bend without damaging the body. So, if you crash, you can finish your ride, replace the blade, and get on with your life at a reasonable price. Contact your local bike shop for details. Avid, LLC 2875 W Oxford Ave # 7 Englewood, CO 80110 USA tel 303. 762. 9353 fax 303. 762. 1133 Website: www. avidbike. com Email: tech@avidbike. com Avid, Speed Dial, and Bend Zone are trademarks of Avid, LLC [. . . ]