User manual DAHON TOURNADO PACKING 2008

[. . . ] · The required braking distance will be longer during wet weather. Reduce your speed and apply the brakes early and gently. · If the road surface is wet, the tires will skid more easily. If the tires skid, you may fall off the bicycle. [. . . ] To avoid this, reduce your speed and apply the brakes early and gently. · Check that the quick release lever is on the right side (the opposite side to the rotor). If the quick release lever is on the same side as the rotor, there is the danger that it may interfere with the rotor, so check that it does not interfere. · It is important to completely understand the operation of your bicycle's brake system. Improper use of your bicycle's brake system may result in a loss of control or an accident, which could lead to severe injury. Because each bicycle may handle differently, be sure to learn the proper braking technique (including brake lever pressure and bicycle control characteristics) and operation of your bicycle. This can be done by consulting your professional bicycle dealer and the bicycle's owners manual, and by practicing your riding and braking technique. · The M545 disc brakes are designed for optimum performance when used in combination with the BR-M545 (calipers), ST-M410 (brake lever), SM-RT61, SM-RT62 (rotor) and Shimano pad unit (M06). The brake lever used should be a two-finger lever for V-brakes, such as the ST-M410. While doing this, tighten the rotor fixing bolts in the order shown in the illustration. Tightening torque: 2 - 4 N·m {18 - 35 in. lbs. } Inner cable Use a flat-tipped screwdriver or similar tool to bend the edges of the tightening plate over the heads of the bolts as shown in Fig. 3 Tightening plate 3 mm Allen key Snap ring Brake pad CAUTION · Disc brakes have a burn-in period, and the braking force will gradually increase as the burn-in period progresses. Make sure that you are aware of any such increases in braking force when using the brakes during the burn-in period. The same thing will happen when the brake pads or rotor are replaced. 2. While depressing the brake lever, set the calipers to the required position and then tighten the caliper fixing bolts. and turn the cable adjusting bolts at the brake lever clockwise to loosen them. Pad adjusting screw <SM-RT62> Note · If the brake caliper mounting boss and the dropout are not parallel, the rotor and caliper may touch. · Parts are not guaranteed against natural wear or deterioration resulting from normal use. · For maximum performance we highly recommend Shimano lubricants and maintenance products. Tightening torque: 6 - 8 N·m {53 - 69 in. [. . . ] · Parts are not guaranteed against natural wear or deterioration resulting from normal use. · For maximum performance we highly recommend Shimano lubricants and maintenance products. Tightening torque: 6 - 8 N·m {53 - 69 in. Loosen the pad adjustment screw by Rotor installation ring Pads two clicks. 3. Be careful not to forget to install the snap ring at this time. Tightening torque: 2 - 4 N·m {18 - 35 in. [. . . ]