User manual DAIKIN BRC7C67

[. . . ] Vielen Dank für den Kauf einer Klimaanlage von Daikin. Bitte lesen Sie diese Bedienungsanleitung vor der Inbetriebnahme des Gerätes gründlich durch. Hier wird erklärt, wie das Gerät richtig eingesetzt wird und was bei Störungen zu tun ist. In dieser Anleitung wird nur das Innenaggregat beschrieben. [. . . ] Do not wash the air conditioner or the remote controller with water, as this may result in electric shocks or fire. Do not place water containers (flower vases, etc. ) on the unit, as this may result in electric shocks or fire. Do not install the air conditioner at any place where there is a danger of flammable gas leakage. In the event of a gas leakage, build-up of gas near the air conditioner may result in fire hazards. Do not put flammable containers, such as spray cans, within 1 m from the blow-off mouth. The containers may explode because the warm air output of the indoor or outdoor unit will affect them. English The batteries must be removed from the appliance before it is scrapped and they are disposed of safely. Arrange the drain to ensure complete drainage. If proper drainage from the outdoor drain pipe does not occur during air conditioner operation, there could be a blockage due to dirt and debris build-up in the pipe. This may result in a water leakage from the indoor unit. Under these circumstances, stop air conditioner operation and consult your dealer for assistance. 1, 2) DISPLAY " " (SIGNAL TRANSMISSION) 1 This lights up when a signal is being transmitted. DISPLAY " "" "" "" " " " (OPERATION MODE) 2 This display shows the current OPERATION MODE. For straight cooling type, " " (Auto) and " are not installed. H M L 11 12 13 14 15 " (Heating) DISPLAY " " 3 (SET TEMPERATURE) This display shows the set temperature. C 16 DISPLAY " hr. 4 (PROGRAMMED TIME) This display shows PROGRAMMED TIME of the system start or stop. 5 6 DISPLAY " " (AIR FLOW FLAP) Refer to page 9. DISPLAY " " " " (FAN SPEED) The display shows the set fan speed. 17 18 TEST " (INSPECTION/ DISPLAY " TEST OPERATION) When the INSPECTION/TEST OPERATION BUTTON is pressed, the display shows the system mode is in. ON/OFF BUTTON Press the button and the system will start. Press the button again and the system will stop. FAN SPEED CONTROL BUTTON Press this button to select the fan speed, HIGH or LOW, of your choice. TEMPERATURE SETTING BUTTON Use this button for SETTING TEMPERATURE (Operates with the front cover of the remote controller closed. ) PROGRAMMING TIMER BUTTON Use this button for programming "START and/or STOP" time. (Operates with the front cover of the remote controller opened. ) TIMER MODE START/STOP BUTTON Refer to page 10. [. . . ] It does not restart immediately because a safety device operates to prevent overload of the system. After 3 minutes, the system will turn on again automatically. · If the reception beep is rapidly repeated 3 times (It sounds only twice when operating normally. ) Control is set to the optional controller for centralized control. · If the defrost lamp on the indoor unit's display is lit when heating is started. [. . . ]